SPARE ACCESSORIES
BATTERY INSTALLATION
1 - Remove the battery cover by pulling on the lower section of the BABY-
Doo
Cleaner MX-One nose cleaner.
®
2 - Insert the 2 alkaline AA batteries and make sure the polarity is correct.
A polarity error may cause damage and affect the warranty.
Never insert chargeable batteries. Use single use batteries. Do not mix
the new and old batteries together.
3 - Replace the battery cover.
Disposal of empty battery to the authorized place.
Collecting party subject to the regulation of each individual territory.
If the unit is not used for a long period, please take out all batteries to
avoid liquid leakage damaging the unit.
18
Visiomed BABYDOO MX-ONE - V5 - 012017
- Réf. : MX-CAPS - Box of 100 spare
hygienic caps
- Réf. : KITEMB3 - Box of 3 hypoaller-
genic silicone probes and 2 silicone
seals
Accessories are available in pharma-
cies and baby stores.
Open / Close
DEVICE ASSEMBLING
1 - After inserting the batteries
for the first time), place a disposable hygienic
caps
in the special compartment
4
2 - Make sure the silicone seal is properly
positioned
, allowing the internal baby nose
2
cleaner to be sealed.
3 - Place the cover
5
back in place, and turn until
the device is sealed closed.
MAKE SURE THE 4 NOTCHES OF THE COVER AND
THE MAIN UNIT ARE FACING EACH OTHER.
4 - Place the probe
.
6
GENERAL ADVICE FOR USE
1 - Turn on the BABYDoo
of the central unit.
2 - Insert carefully the probe in the nostril while holding baby's
head to help it breath.
ADVICE FOR USE :
- During suction, make sure the baby's mouth is open to ensure the pressure
on the inner ear is released.
- Suction duration : 8 seconds per nostril.
- Make sure not to suck the nose wall.
- Do not push the end piece in baby's nostril.
- This movement should not be sudden, avoid excessive pressure that can
harm the ear and sinus.
Repeat as many times as necessary to unclog the nose.
Change hygienic caps as needed.
Visiomed BABYDOO MX-ONE - V5 - 012017
6
(when using
1
5
.
3
2
1
by pressing the switch button in front
®
4
3
19