Cleaning; Storage; Troubleshooting; Replacement Filter - Bucket Head BH01000 Mode D'emploi

Cleaning

To keep your Wet/Dry Vac looking its
best, clean the outside with a cloth
dampened with warm water and mild
soap.
Problem
Vac will not pick up dirt
Vac will not run
Electrical Ratings: BH01000 120 V, 4 A, 60 Hz
WARNING: If any of the power head assembly parts should become
detached or broken, exposing motor or any other electrical components,
operation should be discontinued immediately to avoid personal injury or
further damage to the vacuum. This vacuum has no user serviceable parts,
except the filter.
Replacement filters are available where
you purchased your Vac.
The Stock Number is VF2000.
MAINTENANCE

TROUBLESHOOTING

Cause
1. Clogged filter
2. Clogged hose
3. Air leak
1. No electricity

REPLACEMENT FILTER

(continued)

Storage

Before storing your powerhead, the cord
should be wrapped around the unit to
keep it from getting damaged.
The supply cord cannot be replaced.
If the cord is damaged, the Vac should be
destroyed and replaced.
1. Clean or replace filter (follow
instructions on page 7).
2. Remove hose and clear debris.
3. Make sure power head is
securely attached to bucket and
the bucket is one of the
designated types.
1. Make sure electrical outlet has
voltage. (A qualified electrician
may need to be contacted).
8
Remedy