Pioneer SGY-PM910H Mode D'emploi page 9

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 40
Be careful not to drop or lose the
battery when installing it.
Do not use batteries other than
CR2032.
Install the cover firmly to ensure
water resistant performance.
4.
Check the LED display.
The product starts in pedaling monitor
mode when the batteries are installed.
Check that the LEDs light green for 10
seconds.
If the LEDs do not light for more than 5
seconds after installing the batteries,
remove the batteries once, and after
more than 1 minute, install them
again. If the LEDs still do not light, the
battery may be almost empty. Replace
the battery with a new one.
5.
Install the right transmitter
cover and tighten the screws
to fix it in place.
Use a tool that can measure the torque
to tighten the screws.
Tightening torque: 30 cN·m
Install the transmitter cover and
screw the screws in firmly to ensure
water resistant performance.
Installing and Removing the Batteries
EN
9

Publicité

Table des Matières
loading

Table des Matières