Before The First Use; Filling The Water Tank; Ironing Tips - Di4 Jet Pressing 2850W Manuel D'utilisation

BEFORE THE FIRST USE

Before using the Steam Station, please ensure you read the user manual and understand all parts
and features of the Steam Station. Be sure to remove any packaging material and labels before using
for the first time.
In the first use they can break off odors or fumes that sent quickly. Do not spray for the first time on
clothes and there may be traces of dirt on the soleplate
WATER TO BE USED
The device is designed for use with tap water. If the water in your area is hard or semi-hard use mix
tap water with distilled or demineralized water purchased in stores, in the ratio 2: 1 and 1: 1 respec-
tively. Check with your water supplier to determine the type of water in your area.
Never use 100% distilled or demineralized, rain water, softened water, scented water, water from oth-
er appliances such as refrigerators, air conditioners, dryers or other types of home water preparation
water.

FILLING THE WATER TANK

Locate the water tank release latch under the front of the water tank and push up. This will release the
water tank, enabling you to pull it out.
Place the water tank inlet under a tap and fill. Do NOT fill over the MAX level indicator.
Slide the water tank back in position and push in, you will hear it click when it is locked in place.
OPERATING INSTRUCTIONS
Place the Steam Station on a firm level table, bench or ironing board.
Plug the unit into a power outlet and switch on at the power point.
Wait until the indicator of boiler operating will light on.
Adjust the temperature dial in terms of choose the kind of fabrics that you want to iron.
Note: If you want to use the steam ironing, we suggest you to adjust the temperature dial on MAX.
When the iron operating light indicator goes out the device will be ready for use.
NOTE: During the whole operating time, the iron operating light indicator will go on and off in erratic
intervals, this is normal.
Adjust the steam jet turning the steam temperature dial.
To make the steam jet come out, press the steam button (C), and if you want to stop the steam press
the steam tigger (D), in a few seconds steam will stop.

IRONING TIPS

• Start with the fabrics to be ironed at a low temperature and finish with those which need higher
temperatures.
• For mixed fibre fabric, set the ironing temperature to a lower setting.
• For woollen garments, press the steam trigger repeatedly over the garment without physically
touching it with the iron.
• For thicker fabrics, raise the steam output by turning the steam control dial to the right.
• For low temperature setting on the dial, reduce the steam level by turning the steam control dial to
the left.
17