Furrion AURORA FDUB43CSA Manuel De L'utilisateur page 21

Smart 4k uhd plein soleil, pleine ombre et soleil partiel
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

If the Network Is Not Automatically Connected
Press
/
/ Connection / Network Connection Settings / Wired
Connection (Ethernet).
Setting up a Wireless Network
1.
Turn on the power of the router connected to the Internet.
2. Press the
button on the remote control.
3. Select
/ Connection / Network Connection Settings / Wi-Fi
Connection.
4. When the network search is complete, the list of networks available for
connection is shown.
5. Select a network to connect.
If your Wireless Router is password protected, enter the password configured for
the router.
Network Setting Warnings
Use standard LAN cable.
Resetting the modem may fix some network connection problems. Turn the
power OFF, disconnect and reconnect it, and then turn the power on to solve the
problem.
The manufacturer is not responsible for any network connection problems or any
faults, malfunctions, or errors caused by network connection.
The network connection may not work properly because of network settings or
the Internet service provider.
DSL service must use a DSL modem and cable service must use a cable modem.
Since only a limited number of network connections may be available, TV
network settings may not be used depending on the contract with Internet service
provider. (If the contract does not allow more than one device per line, only the
already-connected PC may be used.)
A wireless network can experience interference from other devices that use
the 2.4 GHz frequency (wireless phone, Bluetooth device, or microwave oven).
Although interference can also happen when using the 5GHz frequency, it is less
likely to occur.
The wireless environment can make wireless network service run slowly.
Failure to turn off all local home networks may cause excessive traffic on some
devices.
The access point device must support wireless connections and wireless
connection feature must be enabled on the device to have AP (access point)
connection. Contact the service provider for availability of wireless connections
on the access point.
- 20 -
CCD-0005519 Rev: 03-22-22

Publicité

Table des Matières
loading

Table des Matières