System Check - Bulldog DC Série Manuel D'instructions

1.5.2 Battery Cable Routing
Route battery connection cables in areas that will not cause them to wear or cut through the insulation
causing a potential short circuit. The winch power wire must be routed to the battery. A direct battery
connection of the power (red) and ground (black) cables is required.
WARNING
ALWAYS route battery cables along a path that allows the cables to be secured with zip ties.
Loose or unsecured power cables can cause serious injury or death.
1. Plan the routing path.
2. Loosely secure power cables along path.
3. Confirm power cables are protected from sharp edges, heat and moving parts. Consider chassis
flex and vibration which might damage cable.
4. Carefully inspect electrical cable routing. Zip tie and secure electrical cables. Zip ties should be
snug, but not cutting into wire insulation. Use electrical tape, pieces of rubber hose or electrical
conduit to protect electrical cables and wire harness where needed to avoid electrical cable insula-
tion wear or abrasion.
5. FIRST attach red (positive) battery cable, then black (negative) battery cable. Install boots as appropri-
ate to protect connections.

1.5.3 System Check

Upon completion of installation,
check winch for proper
operation. The voltage drop
for the winch motor must not
exceed 10% of the nominal
voltage of 12 VDC.
Check for proper drum rotation.
Turn the clutch knob to the
"CLUTCH OUT" position. Pull
out some cable from the drum,
and then turn the clutch knob
to the "CLUTCH IN" position
to engage the gears. Press the
cable out button on the power
switch. If the drum is turning
and releasing more cable then
your connections are accurate.
If the drum is turning and col-
lecting more cable then reverse
the leads on the motor. Repeat
and check rotation.
Installation Instructions
Switch
HORIZON GLOBAL •
Figure 5 - DC2.5, DC3.5, & DC4.5 Wiring Diagram
Red Motor +
Black Motor -
F4106-00 REV A (9528) 11/17
Red Battery +
Black Battery -
9