IVT PL-C004P Notice D'utilisation page 8

CHARGING A LEAD-ACID BATTERY
• First ensure that it is a lead acid battery with a voltage of 6V or 12V.
Rechargeable batteries with other voltages cannot be charged!
• Disconnect all consumers from the rechargeable battery.
• If the rechargeable battery is built into a vehicle, switch off the ignition and all consumers.
Please strictly observe any and all information and safety instructions of the vehicle on how the rechargeable
i
vehicle battery needs to be charged. Modern vehicles are equipped with sensitive electronic components and
control units which will be damaged when handled improperly!
• First, connect the charger to power supply (100 – 240V AC at 50/60 Hz).
• Please connect the proper connection adapter with the charging cable of the device.
• Then, you may select from various functions by activating the MODE button (9). Please strictly observe the information
of the manufacturer of the rechargeable battery concerning permissible final charging voltage and maximum charging
current when selecting the correct operating mode.
• Connect the charger to the rechargeable battery observing correct polarity.
Reverse polarity on the connected rechargeable battery or a defective battery is indicated by LED (6 or 7).
• After charging, disconnect the charger from the power supply.
• Then remove the terminal from the minus pole of the rechargeable battery and then from the plus pole.
CHARGING CURVES
Summer mode 12V:
Motorbike mode 6V:
Winter mode 12V:
Motorbike mode 12V:
8