Specifications - Insignia NS-P2000 Guide De L'utilisateur

Electrical connections
Item Name
A POWER/
BATTERY
B FUSE
C SPEAKER/
BRIDGED

Specifications

Amplifier
RMS power @13.8VDC
Power @ 4 Ohms............................... 200W × 2
Power @ 2 Ohms............................... 300W × 2
Bridged power @ 4 Ohms ................. 500W × 1
Minimum speaker impedance .............. 2 Ohms
THD distortion ....................................... 0.08%
IMD distortion........................................ 0.08%
Frequency response ............................. 20 Hz to 20 KHz
Input sensitivity..................................... 200mV to 6V
Input impedance ................................... 15K Ohms
Signal-to-noise ratio ............................. 90dB
8
A
Function or Control
• +12 Volts - Connect to positive (+) battery
terminal.
• REM - Connect to the Remote cable from the
signal source to control amplifier switching.
Applied voltage must be between 7 and
15VDC.
• GND - Connect to good ground, such as the
car frame or grounded metal body. Keep
ground cable length as short as possible.
Amplifier protection fuse. Replace with the same
type and capacity.
Connect the speakers to these terminals.
www.insignia-products.com
B C