Risco RWX34S Instructions D'installation page 8

RED INDICATOR
When the red LED indicator (see Figure 9) flashes once in 30 seconds, it indicates
the detector is operating normally. When the red LED is illuminated continuously,
and simultaneously an audible alarm sounds, this indicates the detector is
responding to an alarm trigger.
TESTING YOUR SMOKE AND HEAT DETECTOR
To be sure that detector is
working correctly, test the
detector weekly by performing
the following procedure:
1. Use your finger to firmly
press the test button. If the
detector is functioning
correctly, the alarm horn
sounds and an alarm
message is sent to the panel.
2. To stop the alarm horn,
press the test button again.
If the detector fails to test properly, have it repaired or replaced immediately.
If the alarm horn begins to beep once every 35 seconds, it means that the detector's
batteries are weak. Replace the batteries immediately. Keep fresh batteries on hand
for this purpose.
NOTE:
Cooking smoke or a dusty furnace (sometimes called "friendly fires"
to sound. If this happens, open a window or fan the air to remove the smoke or dust. The
alarm will turn off as soon as the air is completely clear. If, however, the smoke alarm
continues, activate the heat-only mode. Do not disconnect the batteries from the detector.
This will cancel your protection from fire.
SMOKE AND HEAT DETECTOR MAINTENANCE
To keep your detector in good working condition, you must test the detector weekly,
according to the "Testing Your Smoke and Heat Detector" section.
Figure 9: Smoke and heat detector Cover
7
)
can cause the alarm