System Setup; Important - EGAmaster MASTERVISION REC Manuel D'instructions

1. IMPORTANT: when connecting the camera to the monitor the power must be off or both
units will be damaged.
2. Screw the camera to the cable reel (see figure A). Connect the reel to the monitor (see figure
B).
3. Plug the power adapter cord into the wall AC socket and other end into the DC 12V-Input jack,
or plug the cord from the battery case power. Plug the power cord of battery case into the 12V-
input jack.
4. Turn on the power switch on the front of the monitor.
5. Gently lower the camera into a pipe duct, etc and reel out the cable until it is at the desired
depth.
6. Turn on the led button and adjust the brightness from the MENU.
7. record the pictures if you need ( see DVR operating).
8. By a video cable you can transfer the picture to other larger screen.
9. When finish, carefully remove the camera from the pipe duct, etc. Screw out the camera and
clean it with a clean, soft and dry cloth then put the camera into the previous position.
4. SYSTEM SET-UP
21