Using The Blender; Tips; Cleaning & Maintenance - Inventum CNB406T Mode D'emploi

4

using the blender

Before plugging into a socket, check that the voltage in your home corresponds with the voltage printed on the bottom of the
appliance.
1. Place the blender on a flat, clean and dry surface.
2. Make sure that the blender is not activated.
3. Put the ingredients in the bottle and lock it by firmly turning on the blade set. Turn the drinks bottle around and place it upright on
the motor base unit. Make sure that the •• indications are in line and click the bottle tight by turning it slightly to the left.
4. Switch the blender on by selecting a position with the position button.
cause engine problems. Do not use the mixer for more then 1 minute continuously, wait 1 minute before you operate it again.
5. When the blender has finished mixing switch the button to off (0) and wait until the blades have stopped turning.
6. Click the bottle loose - do not turn too far - and lift it from the motor base unit. Attention: if you turn the bottle too far you turn
the bottle off the blade set and the contents will flow out of the bottle.
7. Turn the drinks bottle around, remove the blade set and firmly turn the lid with drinking spout onto the drinks bottle. You're ready to
go!
Attention: you cannot make warm dishes in the to-go drinks bottle.
5

tips

• When the bottle is cracked, do not use the mixer anymore. This could lead to damage while using the mixer.
• Always add liquid ingredients before adding solid ingredients in the mixer.
• The mixer mixes best when you do not add pieces which are too large.
• Always add a half a cup of liquids when you crush ice cubes.
• When the ingredients stick to the sides of the jug or are not mixed properly, shut off the engine: wait until the knives have stopped
turning. Remove the bottle and shake it before mixing further.
• To prevent the ingredients from being blend to small, take into account that the mixer mixes in seconds, not minutes!
6
cleaning & maintenance
Always unplug the cord from the socket before cleaning the appliance.
• Wipe the base with a damp cloth. Do not use any abrasive or strong detergents.
• Never place the appliance, the power cable or the plug in water or any other liquid.
• Remove the knives from the bottle. Be careful, the knives are extremely sharp. Clean the knives as a whole do not try to take them
apart. Attention: do not use any abrasive or strong detergents.
• The following parts can be cleaned by hand: the bottles, the knive assembly and the lids.
assembly. The knives are very sharp.
CNB406T-instructions.indd 11
Attention: Do not activate the mixer constantly, this can
Be careful when cleaning the knive
English • 11
4-6-2018 13:38:32