Beper 50.923 Manuel D'instructions page 11

Vacuum Cleaner Use instructions
Variable Suction Control
Note:
Once all attachments are in place, unwind a sufficient length of cable and insert the plug into the
wall outlet. A yellow mark on the power cord shows the ideal cable lenghth. Do not pull the power
cord beyond the red mark..
1. Insert the power plug into the wall outlet.
2. Press the power on/off button located the unit to turn the vacuum cleaner "on".
3. To rewind the power cord, press the cord rewind button with one hand and guide the power cord
with the other hand to ensure that it dose not whip causing damage or injury.
4. To adjust the suction, slide the speed control button on the suction hand to control the suction
power of the vacuum cleaner.
Motor Thermostat
Important:
This motor is equipped with a motor protective thermostat. If for some reason the vacuum cleaner
should overheat, the thermostat will automatically turn the unit off. Should this occur unplug the
vacuum cleaner from the wall outlet and turn off switch. Remover dust cup and empty Clean dust
cup filter. Allow the unit to cool for approximately 1 hour. To restart, replug into wall outlet and turn
switch back on.
Emptying the dust box:
- Empty the vacuum deposit when dust is visible though the transparent walls, when it is full, or when
the vacuum cleaner does not work to its full potential.
- Disconnect the hose from the vacuum cleaner's air intake.
- Disconnect the dust box from the appliance. (Fig. 4)
- Open the lid of the dust box and empty the contents into the appropriate waste disposal receptacle.
- Check the condition of the dust box filter.
- Check the condition of the motor filter.
- Close the lid of the dust box.
- Attach the dust box to the appliance.
- Connect the hose to the vacuum cleaner's air intake.
Carry and move away the cleaner:
Note:
There is a handle on the top. You could use it to conveniently carry the cleaner .
Changing the filters:
- Motor filter, it is advisable to be changed at least once a year or every 100 hours of the appliance's
use.
- Motor filter, it is advisable to be changed at least once a year or every 100 hours of the appliance's
use.
11