Beper 50.923 Manuel D'instructions page 10

Vacuum Cleaner Use instructions
Use and function
Assembling vacuum cleaner
Vacuuming function:
- Fit the hose unit to the vacuum cleaner's air intake.
- To disconnect the hose unit from the vacuum cleaner, press the two
buttons on the hose joint at the same time and pull outwards (Fig. 1)
Insertion of accessories into the appliance's grip:
- The appliance's grip is designed in such a way that it allows the insertion of the following accesso-
ries: (use the combination that best meets your requirements)
- Designed to provide access to surfaces which are out of reach and make floor cleaning comforta-
ble, its length can be adjusted by using the adjustment control. (Fig. 2)
- Lid: Specially designed for cleaning floors (both rugs, carpets and hard floors), its base has a re-
tractable brush that can be adjusted to two heights for greater efficiency on these floors.
- Vacuum cleaner base for delicate floors: specially designed for delicate floors, such as parquet
wooden flooring.
- Lance: Specially designed for getting into cracks and difficult corners.
- Upholstery brush: Especially suitable for cleaning textile surfaces.
Use:
- Take the length of cable required out of the housing.
- Connect the appliance to the mains.
- Turn the appliance on using the on/ off switch.
Once you have finished using the appliance:
- Turn the appliance off, using the on/ off switch.
- Unplug the appliance to the mains.
- Retract the cable by pressing the roller cable button and guide the cable into the appliance.
Carry handle/s:
- The device has a handle on the upper part so it can be transported easily and comfortably.
Parking position:
- This appliance has two parking positions for comfortable and straightforward storage.
- To use the horizontal parking position, fix the break pad hook to the hook situated on the rear side
of the appliance (Fig. 3)
Safety thermal protector:
- The appliance has a safety device, which protects the appliance from overheating.
- If the appliance turns itself off and does not switch itself on again, disconnect it from the mains
supply, and wait for approximately 15 minutes before reconnecting. If the machine does not start
again seek authorized technical assistance.
10