Component List; Electrical Connection - CTC 585514 401 Mode D'emploi

EN
Assembly instructions - CTC BMS/Internet (Modbus)
General
The CTC BMS/Internet allows BMS (Building
Management System) or Internet monitoring
to be connected to the heating system.
Safety Instructions.
The installation can be performed by anyone,
as no high voltage components are to be
opened.
This appliance is not intended for use by
persons ( including children ) with reduced
physical, sensory or mental capabilities,
or lack of experience and knowledge,
unless they have been given supervision or
instruction concerning use of the appliance
by a person responsible for their safety.
Children should be supervised to ensure that
they do not play with the appliance.
!
Turn off the power switch
before installing the unit.
Communication
master
CTC BMS
6

Component list

• CTC BMS/Internet
• Cable clip
• Cable (Display/Interface)

Electrical connection

Snap the enclosed cable into the interface
and the free connector on the right hand side
of the bottom edge of the display.
Building Management System
(BMS)
Connect the RS485 cable to the jackable
terminal and secure using the stress reliever.
Cable not included.
Fit the jumper plugs in the desired position.
This determines whether or not termination is
engaged.
Display