Checking The Connections Of Cables And The Installation Positions - Pioneer AVG-VDP1 Mode D'emploi

Checking the Vehicle
Dynamics Processor Status
! ANG. V (L)  Angular velocity (left)
! ANG. V (R)  Angular velocity (right)
! Odometer  Odometer (trip meter)
# To reset the session records, touch Reset.
Note
You can set up that the
as breaking your best running records. To turn
icon display on or off, touch On/Off. When turn-
ing icon display on,
key.
Checking the connections
of cables and the
installation positions
You can check that cables are properly con-
nected between this unit and the vehicle.
% Touch Menu and then touch
Connection Status to display the connec-
tion status.
! Speed Pulse
Shows the speed pulse value detected by
this unit. 0 is displayed while the vehicle is
stationary.
! GPS Antenna
Shows the status of the GPS antenna; con-
nection status, the reception sensitivity and
the number of satellites the signal is re-
ceived.
 Reception sensitivity is shown in the
range from 0 to 3. Install the GPS anten-
icon appears as soon
is highlighted on On/Off
na on the place with the reception sensi-
tivity 2 or 3.
! Installation Position
Shows the installation status of this unit.
! Power Voltage
Shows the power supply (reference value)
provided from the vehicle battery to this
unit. If the voltage does not fall within the
range of 11 to 15 V, check whether power
cable connection is correct.
! Parking Brake
Shows the connection status of the parking
brake. When the parking brake is applied,
On is displayed. When the parking brake is
released, Off is displayed.
! Back Signal
Shows the status of the back signal. When
the gear shift is in REVERSE (R) position,
the signal switches to High or Low. (Which
of these is displayed depends on the
vehicle.)
Section
07
25
En