Maintenance; Glass Information; Maintenance Of Motors - HAMPTON BAY SF103-18H Guide D'utilisation Et D'entretien

Operation (continued)
REMOTE CONTROL INFORMATION
The infrared remote control relies on a line of sight and must be pointed at
the flame/screen of the fireplace to work. The remote control unit has the
controls required to turn ON/OFF both the main power and the heater. If you
prefer to use the touchpad control on the fireplace unit itself, open the
control panel sliding cover to access the touchpad buttons. The layout of
the buttons on touchpads and remote control unit can be seen on
the previous page.
Battery Replacement Procedure: (Size CR2025)
Battery replacement instruction

Maintenance

GLASS INFORMATION

□ Under no circumstances should this product be operated with broken glass.
□ Do not strike or slam the glass.
□ Do not use abrasive cleaners to clean the glass.
□ This product uses tempered glass. Replacement of the glass supplied by the manufacturer should be done by a qualified
service person.

MAINTENANCE OF MOTORS

□ Always disconnect the appliance from the main power supply and allow it to cool before any servicing operation.
□ The motors used on the fan heater and flame blower are pre-lubricated for extended bearing life and require no further
lubrication. However, periodic cleaning/vacuuming of the appliance around the air intake and exhaust, as well as the fan heater
is recommended. For heavy or continuous use, periodic cleaning must be done more frequently. If the heater blows alternating
cold and warm air, check the fan for free movement and for debris restricting air flow. If the fan does not move freely, the unit
should be turned off and the fan replaced immediately in order to prevent further damage to the unit.
CR2025
OPEN
PUSH
RELEASE
The plastic tab inside the battery
compartment MUST be removed
before the remote control will operate.
11
Please contact 855-HD-HAMPTON for further assistance.
(Pull Tab)
HAMPTONBAY.COM