Electricity Supply - RedHotDot ALUMINIUM TU-95 Notice D'utilisation

EN
ALUMINIUM TU-95
Thank you for choosing this RHD product; please read this instruction manual carefully before installing
and using the product, and keep in a safe place for future reference.
This machine was conceived to weld M 4 studs on car body for bumps and impacts elimination on
Aluminium car body.
Caution:
For an optimal operation, it is recommended to use the earth cable and gun delivered with the machine.
ENVIRONMENT
This equipment must only be used for welding operations in accordance with the limits indicated on the
descriptive panel and/or in the user manual. The operator must respect the safety precautions that apply to
this type of welding. In case of inedaquate or unsafe use, the manufacturer cannot be held liable for damage
or injury.
This equipment must be used and stored in a place protected from dust, acid or any other corrosive agent.
Operate the machine in an open, or well-ventilated area.
Operating temperature: Use between -10 and +40°C (+14 and +104°F).
Store between -20 and +55°C (-4 and 131°F). Air humidity: Lower or equal to 50% at 40°C (104°F).
Lower or equal to 90% at 20°C (68°F).
Altitude: Up to 1000 meters above sea level (3280 feet).
TRANSPORT AND TRANSIT OF THE WELDING MACHINE
The machine is fitted with handle(s) to facilitate transportation. Be careful not to underestimate the
machine's weight. The handle(s) cannot be used for slinging.
Do not use the cables or torch to move the machine. The welding equipment must be moved in an upright
position. Do not place/carry the unit over people or objects.

ELECTRICITY SUPPLY

Single phase power supply from 110 to 240V 50/60Hz with earth. 16A Circuit breaker curve D or 16A fuse
(mini 5A).
NB: If the product trips the circuit breaker, please check that the correct fuse and an adequate circuit
breaker are being used.
- These are A-class devices. They are designed to be used in an industrial or professional environment. In a
different en- vironment, it can be difficult to ensure electromagnetic compatibility, due to conducted
disturbances as well as radiation.
- Warning: these materials do not comply with IEC 61000-3-12. If they are to be connected to a low-voltage
main supply, it is the responsibility of the user to ensure they can be connected. If necessary consult the
operator of your electrical distribution system.
The horizontal segment at the centre of the display flashes red to indicate that the device is powered.
12