Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
• Connect the hose of a vacuum cleaner to the
dust extraction adapter (11).
Hints for optimum use
• Clamp the workpiece. Use a clamping device for
small workpieces.
• Draw a line to define the direction in which to
guide the saw blade.
• Firmly hold the machine by the grip.
• Set the sawing speed.
• Set the mitre angle.
• Switch on the machine.
• Wait until the machine has reached full speed.
• Place the saw shoe on the workpiece.
• Slowly move the machine along the pre-drawn
line, firmly pressing the saw shoe against the
workpiece.
• Do not apply too much pressure on the machi-
ne. Let the machine do the work.
• Switch off the machine and wait for the ma-
chine to come to a complete standstill before
putting the machine down.
5. MAINTENANCE
Always disconnect the machine from the
main power supply before carrying out
any maintenance work.
Clean the machine casings regularly with a soft
cloth, preferably after each use. Make sure that the
ventilation openings are free of dust and dirt. Re-
move very persistent dirt using a soft cloth moiste-
ned with soapsuds. Do not use any solvents such
as gasoline, alcohol, ammonia, etc. Chemicals such
as these will damage the synthetic components.
Regularly clean the saw blade to avoid
inaccuracies during use.
Regularly lubricate the guide roller.
Replacing the saw blade (Fig. B)
Worn or damaged saw blades must be replaced
immediately.
Only use sharp and undamaged saw blades.
• To remove the old saw blade (15), proceed as
described in the section „fitting and removing
saw blade".
• To mount the new saw blade (15), proceed as
8
described in the section „fitting and removing
saw blade".
ENVIRONMENT
Faulty and/or discarded electrical or
electronic apparatus have to be collected at
the appropriate recycling locations.
Only for EC countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2012/19/
EC for Waste Electrical and Electronic Equipment
and its implementation into national right, power
tools that are no longer usable must be collected
separately and disposed of in an environmentally
friendly way.
WARRANTY
VONROC products are developed to the highest
quality standards and are guaranteed free of
defects in both materials and workmanship for the
period lawfully stipulated starting from the date of
original purchase. Should the product develop any
failure during this period due to defective material
and/or workmanship then contact VONROC directly.
The following circumstances are excluded from this
guarantee:
• Repairs and or alterations have been made
or attempted to the machine by unauthorized
service centers;
• Normal wear and tear;
• The tool has been abused, misused or
improperly maintained;
• Non-original spare parts have been used.
This constitutes the sole warranty made by compa-
ny either expressed or implied. There are no other
warranties expressed or implied which extend
beyond the face hereof, herein, including the
implied warranties of merchantability and fitness
for a particular purpose. In no event shall VONROC
be liable for any incidental or consequential dama-
ges. The dealers remedies shall be limited to repair
or replacement of nonconforming units or parts.
The product and the user manual are subject to
change. Specifications can be changed without
further notice.
WWW.VONROC.COM
Publicité
Table des Matières
