Conrad 560067 Mode D'emploi page 3

Ioniser with air cleaner
Item no. 560067
Intended use
This product is intended to improve the air quality by emitting negative static charge to the dust collector
inside. Small particles, such as dust, pollen, smoke and exhaust gases, which are normally positively
charged, will be attracted to the dust collector and removed from air. Furthermore, the ultraviolet emitted
from the air purifier can exterminate bacteria. The air purifier has a snooze function. It is intended for indoor
use only. Do not use it outdoors. Contact with moisture, e.g. in bathrooms, must be avoided under all
circumstances.
For safety and approval purposes (CE), you must not rebuild and/or modify this product. If you use the
product for purposes other than those described above, the product may be damaged. In addition, improper
use can cause hazards such as short circuiting, fire, electric shock etc. Read the instructions carefully and
keep them. Make this product available to third parties only together with its operating instructions.
This product complies with the statutory national and European requirements. All company names and
product names are trademarks of their respective owners. All rights reserved.
Delivery content
• Ioniser with air cleaner
• Remote control
• CR2025 battery
• Operating instructions
Safety instructions
Read the operating instructions carefully and especially observe the safety information.
If you do not follow the safety instructions and information on proper handling in this
manual, we assume no liability for any resulting personal injury or damage to property.
Such cases will invalidate the warranty/guarantee.
a) Persons / Product
• Avoid exposing yourself excessively to ultraviolet light. Persons should maintain a distance of
at least 30 cm from the product. Never look directly into the UV light and never position your
face directly in front of the front or rear grating during operation. However, radiation at close
range for a brief period is not dangerous.
• Switch the product off before pulling the mains plug out of the socket.
• The product should not be placed on metallic surfaces or directly on a carpet.
• The air vents in the product must never be covered or blocked.
• Never pull the mains plug from the socket by pulling at the cable. Always pull it from the mains
socket using the intended grips.
• Unplug the mains plug from the mains socket if you do not use the device for an extended
period of time.
• Disconnect the mains plug from the mains socket in thunderstorms for reasons of safety.
• Make sure that the mains cable is not squeezed, bent, damaged by sharp edges or put under
mechanical stress. Avoid excessive thermal stress on the mains cable from extreme heat or
cold. Do not modify the mains cable. Otherwise the mains cable may be damaged. A damaged
mains cable can cause a deadly electric shock.
• Do not touch the mains cable if it is damaged. First, power down the respective mains socket
(e.g. via the respective circuit breaker) and then carefully pull the mains plug from the mains
socket. Never use the product if the mains cable is damaged.
• A damaged mains cable may only be replaced by the manufacturer, a workshop commissioned
by the manufacturer or a similarly qualified person, so as to prevent any danger.
• Never plug in or unplug the mains plug when your hands are wet.
• The product is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. These may become dangerous
playing material for children.
• Protect the product from extreme temperatures, direct sunlight, strong jolts, high humidity,
moisture, flammable gases, vapours and solvents.
• Do not place the product under any mechanical stress.
• If it is no longer possible to operate the product safely, take it out of operation and protect it from
any accidental use. Safe operation can no longer be guaranteed if the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions or
- has been subjected to any serious transport-related stresses.
• Handle the product carefully. Jolts, impacts or a fall even from a low height can damage the
product.
• Also observe the safety and operating instructions of any other devices which are connected
to the product.
b) (Rechargeable) batteries
• Correct polarity must be observed while inserting the (rechargeable) batteries.
• (Rechargeable) batteries should be removed from the device if it is not used for a long period
of time to avoid damage through leaking. Leaking or damaged (rechargeable) batteries might
Version 02/14
cause acid burns when in contact with skin, therefore use suitable protective gloves to handle
corrupted (rechargeable) batteries.
• (Rechargeable) batteries must be kept out of reach of children. Do not leave (rechargeable)
batteries lying around, as there is risk, that children or pets swallow them.
• All (rechargeable) batteries should be replaced at the same time. Mixing old and new
(rechargeable) batteries in the device can lead to (rechargeable) battery leakage and device
damage.
• (Rechargeable) batteries must not be dismantled, short-circuited or thrown into fire. Never
recharge non-rechargeable batteries. There is a risk of explosion!
c) Miscellaneous
• Consult an expert when in doubt about operation, safety or connection of the device.
• Maintenance, modifications and repairs are to be performed exclusively by an expert or at a
qualified shop.
• If you have questions which remain unanswered by these operating instructions, contact our
technical support service or other technical personnel.
Operating elements
Top view: air purifier
1 POWER button
2 UV button
3 FAN button
4 TIMER button
5 O-ION button
6 Storage compartment for remote control
(hidden)
7 Dust catcher
8 Dust catcher button
Positioning
1. Position the air purifier on a level and sturdy surface, where there are no obstructions to the front and
rear grills.
2. Direct it towards the part of the room normally occupied. Avoid corners, constructions or alcoves.
Operation
1. Plug the mains plug of the product into an earthed mains socket.
2. Press the POWER button (1) to turn the product on or off. The button lights up in blue when the device
is switched on.
3. Press TIMER button (4) to set the sleep timer, from one, two, four, five, six to seven hours. The control
LEDs next to the button indicate the set snooze time.
4. Press the FAN button (3) to turn the fan on or off. The control LED next to the button lights up when the
function is switched on.
5. Press the UV button (2) to switch the ultraviolet radiation on or off. The control LED next to the button
lights up when the function is switched on.
6. Press the O-ION button (5) to regulate the amount of negative oxygen ions released. The "LOW," "MED"
and "HI" control LEDs light up to indicate the setting that was selected.
The air purifier will generate negative oxygen ions continuously.
HI:
The air purifier will generate negative oxygen ions for 60 seconds and then stop generating
MED:
for the next 60 seconds.
The air purifier will generate negative oxygen ions for 15 seconds and then stop generating
LOW:
for the next 105 seconds.
Choose the proper operation setting according to room size and air pollution level.
1
2
3
4
5
6
7
8
Remote control
9 ON/OFF button
10 UV button
11 FAN button
12 O-ION button
13 TIMER button
14 Battery compartment (hidden)
9
10
11
12
13
14