VONROC WC502AC Traduction De La Notice Originale page 11

dust extraction adapter.
- If the vacuum device breaks down, stop
work immediately, switch off the
machine, remove the mains plug from
the mains, and try to solve the problem.
• Insert the dust extraction adapter (22) into the
dust extraction connection (9).
• Connect the hose of a vacuum device to the
dust extraction adapter (22).
Hints for optimum use
• Draw lines to define the direction in which to
guide the cutting discs.
• Hold the machine with both hands. Keep your
second hand on the auxiliary grip (11).
• Set the slot width.
• Take one of the following steps:
- Lower the machine into the wall and set the
slot depth (recommended). The machine is
placed against the wall and the cutting discs
lower into the wall in order to set the slot
depth more accurately.
- Set the slot depth and lower the machine
into the wall.
• Place the machine with the guide roller (8) on
the wall. Make sure that the cutting discs align
with the drawn lines on the wall.
• Set the slot depth.
• Switch on the machine.
• Wait until the machine has reached full speed.
• Slowly move the machine along the pre-drawn
lines from top to bottom, firmly pressing the
guide roller (8) against the wall (fig.H).
• Do not apply too much pressure on the machi-
ne. Let the machine do the work.
• Switch off the machine and wait for the ma-
chine to come to a complete standstill before
putting the machine down.
5. MAINTENANCE
Always disconnect the machine from the
main power supply before carrying out any
maintenance work.
Clean the machine casings regularly with a soft
cloth, preferably after each use. Make sure that the
ventilation openings are free of dust and dirt.
Remove very persistent dirt using a soft cloth
moistened with soapsuds. Do not use any solvents
WWW.VONROC.COM
such as gasoline, alcohol, ammonia, etc. Chemicals
such as these will damage the synthetic components.
Replacing the batteries (fig. I)
The laser uses 2 AAA batteries. If the laser stops
working, the batteries must be replaced.
• Remove the cover (26) from the battery com-
partment (25).
• Remove the old batteries (27).
• Place the new batteries (27).
• Mount the cover (27) to the battery compart-
ment (25).
ENVIRONMENT
Faulty and/or discarded electrical or
electronic apparatus have to be collected at
the appropriate recycling locations.
Only for EC countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2012/19/
EC for Waste Electrical and Electronic Equipment
and its implementation into national right, power
tools that are no longer usable must be collected
separately and disposed of in an environmentally
friendly way.
WARRANTY
VONROC products are developed to the highest
quality standards and are guaranteed free of
defects in both materials and workmanship for the
period lawfully stipulated starting from the date of
original purchase. Should the product develop any
failure during this period due to defective material
and/or workmanship then contact VONROC directly.
The following circumstances are excluded from this
guarantee:
• Repairs and or alterations have been made
or attempted to the machine by unauthorized
service centers;
• Normal wear and tear;
• The tool has been abused, misused or
improperly maintained;
• Non-original spare parts have been used.
This constitutes the sole warranty made by compa-
ny either expressed or implied. There are no other
warranties expressed or implied which extend
EN
11