Operation - Husqvarna DE 110S Manuel D'utilisation

WARNING:
as cutters, grinders, drills, that sand or form
material can generate dust and vapours
which may contain hazardous chemicals.
Check the nature of the material you intend
to process and use an appropriate breathing
mask.
It is not possible to cover every conceivable situation
you can face when using the product. Always exercise
care and use your common sense. Avoid all situations
which you consider to be beyond your capability. If
you still feel uncertain about operating procedures after
reading these instructions, you should consult an expert
before continuing.
Grounded product instructions
WARNING:
result in electrical shock. Speak to an
approved electrician if you are not sure if
your mains outlet is correctly grounded.
Do not do modifications to the power plug
from its factory specification. If the power
plug or power cord is damaged or must be
replaced, speak to your Husqvarna service
agent. Obey local regulations and laws.
If you do not fully understand the
instructions about the grounded product,
speak to an approved electrician.
Use only grounded outdoor extension cables with
grounding plugs and grounding outlet that accepts the
product power plug.
The product has a grounded power cord and power
plug. Always connect the product to a grounded mains
outlet. This decreases the risk of electrical shock if there
is a malfunction.
Use nominal 120V supply circuit with this product.
Do not use electrical adapters with the product.
To do before you operate the product
WARNING:
injury, make sure that you attach the product
plug fully to the extension cable. Do regular
checks of the connection while you operate
the product to make sure that it is fully
attached. Do not use an extension cable that
makes a loose connection.
1587 - 007 - 24.01.2022
The use of products such

Operation

Incorrect connection can
To prevent the risk of
Do not hesitate to contact your Husqvarna
representative if you have any more questions about the
use of the product. We will willingly be of service and
provide you with advice as well as help you to use your
product both efficiently and safely.
Let your Husqvarna dealer check the product regularly
and make essential adjustments and repairs.
Husqvarna AB has a policy of continuous product
development. Husqvarna reserves the right to modify
the design and appearance of products without prior
notice and without further obligation introduce design
modifications.
All information and all data in the operator's manual
were applicable at the time the operator's manual was
sent to print.
Note:
The operation conditions are 800 m/2625 ft
maximum altitude, temperature between -10⁰C/14⁰F to
+40⁰C/104⁰F and humidity 85%.
Note:
Read the operator's manual of the attached
equipment carefully. If specified requirements or settings
are given for the dust extractor, make sure that you obey
these.
1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Do the daily maintenance. Refer to
schedule on page 16 .
3. Make sure that the work area is clean and bright.
4. Use personal protective equipment. Refer to
Personal protective equipment on page 12 .
5. Make sure that the product is installed correctly.
6. Make sure that the frequency and voltage shown on
the type plate agrees with the power supply voltage.
This is also applicable for the extension cables.
7. Attach the product cord (A) with the extension cable
(B) during operation to make sure that they stay
connected. (Fig. 3)
To attach the dust extraction hose
WARNING:
prevent antistatic effects.
1. Open the hose connector. (Fig. 4)
2. Put the hose adapter in the hose connector. (Fig. 5)
3. Push the hose adapter until you hear a click to get it
in correct position.
Maintenance
Use an antistatic hose to
13