YBA Passion CDT450 CD Transport Livret D'utilisation page 5

CAUTION
Before connecting any input or output.....
Always make sure your CDT450 is in the OFF position. If you have any doubt, unplug the AC power cable
from the wall.
Make sure any components connected to your CD Player are off.
Neatly arrange and organize wiring to and from your CDT450 and to and from all your components.
Separate AC wires from audio cables to prevent hum or other unwanted noise from being introduced into
the system.
Discovering your CDT450: Front view
1 2
ON/OFF switch: Use this button to switch ON or switch OFF your CDT450.
1
ON/OFF: Press this button to switch the CD On/Standby
2
STOP/PLAY PAUSE: If you push the key up while a disc is playing, it will stop. Push the key down to
3
start reading the disc. If you push the key down while a disc is playing, it will pause. Push the key
down again to resume playing.
4 / : Push the key up to return to previous track. Push the key down to access to next track.
2
SRC: Use this button to increase the sampling rate.
5
DISPLAY and IR sensor: Any information concerning your CDT450 will be indicated here. Point the
6
remote control to this zone to control your CDT450 from a distance.
Using the player
7
Open the sliding door and remove the disc clamp
Place the disc on the platter and replace the clamp
Slide the door about 2 cm; the disc starts to spin, and tracking is displayed
When you want to load a new CD, press the STOP button and then slide the door
3 4 5
www.ybahifi.com
Passion CDT450 CD Transport
6
Page 5