ARDES AR372 Mode D'emploi page 8

Use the control panel to:
- Adjust the luminous intensity of the ardent block by pressing keys + o - (2-3).
- adjust the power by pressing key 4.
On the first pulse the appliance operates on half power; by pressing the key in
sequence, it cyclically operates as follows: maximum power – off – half power –
maximum etc
During functioning on half power one warning light switches on, whilst on maximum
power both warning lights switch on.
- set the TIMER by pressing key 5:
With each pulse the led corresponding to the selected time switches on.
The timer can be programmed from a minimum of half an hour to a maximum of
7.5 hours.
Example: if the 1/2h, 1h and 2h warning lights are switched on, the timer is
programmed until the appliance switches off after 3 h and 1/2h.
OPERATING WITH REMOTE CONTROL
The equipment can be made to function by using the remote control provided.
The functions available on the remote control are switch on and switch off with
ON-OFF key (6), TIMER programmer (key 7), power selection (keys 8) and the
adjustment of the luminous intensity (keys 9 and 10).
led
1
Disconnect the plug from the socket and let the appliance cool down well
before cleaning it.
This appliance does not require any special maintenance.
In order to clean the appliance, use a soft or slight damp cloth.
Never use abrasives or chemical solvents.
Do not use very wet substances, liquids or cloths to prevent water from entering into
the appliance and irreparably damaging it.
NEVER IMMERSE THE APPLIANCE INTO THE WATER.
Flame effect light replacement.
Ensure the equipment is off and not connected to the electricity supply.
Remove the rear door by unscrewing the specific screws, change the bulb and
reposition the door ensuring you close it correctly.
8
5 2-3
MAINTENANCE
7
led
9
4
6
8
10