Charging Process - Flex BW 18.0-EC Mode D'emploi

3. Attach the reducing nozzle, ensuring an
exact fit.
4. Set the speed to the required setting.
5. Hold the power tool with one hand on
the handle and assume the working
position.
6. Switch on the power tool.
At the end of work:
7. Release the switch.
Charger
1 Insertion slot for battery
2 Contacts
3 Ventilation slots
4 Operating state display
5 Power cord with mains plug
The CA 10.8/18.0 charger is designed to
charge FLEX batteries of the following types
Ó AP 10.8 (2.5 Ah),
Ó AP 18.0 (2.5 Ah),
Ó AP 10.8 (5.0 Ah),
Ó AP 18.0 (5.0 Ah).
Tips for a long battery service life
CAUTION!
Never charge batteries at temperatures
below 0 °C or above 55 °C.
Do not charge batteries in environments with
high air humidity or ambient temperature
Do not cover batteries and the charger during
the charging process.
Pull out the charger mains plug at the end of
the charging process.
20
Battery and charger heat up during the
charging process. This is perfectly normal!
Lithium-ion batteries do not exhibit the
established "memory effect". Nevertheless,
a battery should be completely discharged
before charging and the charging process
should always be fully completed.
If batteries are not used for an extended
period of time, store them partially charged
in a cool place.

Charging process

CAUTION!
Insert only original batteries in the supplied
charger.
 Insert the charger mains plug. The display
backlighting lights up green for 2 seconds
and then goes out again. OK is displayed.
 Insert the battery fully into the charger
until it clicks into place.
– The time remaining in the charging
process (until the battery is fully
charged) and a graphic representation
of the state of charge are shown
alternately in the display.
– The display backlighting lights up
orange when the battery is charged
less than 80%.
– When the battery charge reaches 80%
the display lights up green and OK is
indicated.
BW 18.0-EC