Care And Cleaning - Platinum FT-40M Manuel D'instructions

ENGLISH
OPERATION INSTRUCTIONS
1. Turn the speed control to select speeds: 0(off) and speeds I (Low), II (Middle), III (High).
2. The desk fan can operate in oscillation or stationary mode. Press the Oscillation Knob down to
activate the oscillating mode. To stop oscillation, pull the knob upward. To adjust the tilt of the desk
fan grasp the desk fan motor housing and gently push forward or backward. The desk fan head can
adjusts 30 degree tilt angle.

CARE AND CLEANING

Unplug the desk fan before cleaning or making repairs. NOTE: If for any reason this unit requires service,
return appliance to manufacturer or a similarly qualified service agent to ensure safety.
Cleaning：
To clean: Disconnect the power cord from the socket. Remove the grille and the blades carefully.

Do not drop the blades! First use a soft cloth with light soap to clean off oil stains. Then wipe dry
and polish with a dry cloth. Never use polish or any corrosive liquid that will damage the paint,
metal or plastic! Put back the blades and lock the guard securely before use.
Set the switch to off and unplug the unit.

Clean using a damp cloth and a mild soap detergent, if necessary. Make certain all detergent

residue is removed.
Never use abrasive cleaning agents or solvents. This may cause damage or deterioration to the

surface of the unit.
Do not allow water to drip on or into the desk fan motor housing.

Maintenance:
Make certain the desk fan is unplugged. Unlock the metal clips on the front grill and remove the

front grill. Use a Phillips screwdriver to loosen the securing screw and remove the desk fan blade.
The desk fan blade and grill may be cleaned with a damp cloth and mild detergent.

Reassemble the desk fan after the parts have dried completely. To do so, replace the desk fan

blade, tighten the securing screw, and secure the front grill. Do not plug the desk fan into an
electrical outlet until it is fully reassembled.
7. Slide the desk fan blade onto the mounting shaft with the
shaft sleeve facing to the motor. Align securing screw with
flat groove in the motor shaft and tighten with Phillips
screwdriver.
8. Remove the small securing bolt from the bottom of the
front grill. Position front grill so the logo is horizontal and
make sure the grill clips are open. Secure the top tab to the
back grill. Fasten the grills together with securing bolt. Hold
the front grill against the back grill and snap the grill clips
closed to complete the assembly.