Hdd Installation - RISCO Group VUpoint Série Guide D'installation

HDD Installation

DANGER
Shut down the device and then unplug the power cable before you open the
case to replace the HDD!
All figures listed below are for reference only!
For first time installation, please check if the HDD was previously installed.
Please use HDD of 7200rpm or higher.

Loosen the screws on
the bottom of the chassis.

Connect the Data
cable and power cable to
the HDD and the
mainboard respectively.

Align the HDD with
the four holes in the
bottom.

Put back the cover
and then attach the
screws to the rear panel.
The installation is
complete.
6

Turn the device
upside down and then
secure the screws
(supplied) firmly.