Klarstein SKAL Instructions D'utilisation Et Consignes De Sécurité page 28

EN
28
The difference between code No 23 and 24 is the safety clasp quantity. Pull up the
safety clasp carefully, turn around and take it out from the keg; replaced it by the sealant
(like code No 20 sealant) provided in the beer cooler, attach it to the beer keg, and
pierce it by cooler piercing pin.
Note: Important: Before replacing the sealants or piercing the cooler kit, you must
always follow the instructions marked on the keg to eliminate the excess gas and
ensure that the keg has rested long enough to avoid foam coming out through the
cooler piercing pin /tap faucet. And it is no need to release the gas and replace
the seal rubber if you use Heineken keg, because Heineken keg has its own CO₂
pressure inside, and no need to be provided from outer CO₂ pressure system.