Hls Ps25 / Hls Ps50 Characteristics - Honeywell HLS PS Série Manuel D'utilisation

HLS PS25
HLS PS50
HW_MN-DT-1305_C

3. HLS PS25 / HLS PS50 CHARACTERISTICS

These Power Supplies Units are designed to comply with the requirements
of EN54-4 in order to provide fire control systems with backup supply.
The HLS PS Series operates at 115/230 Vac and 50/60 Hz.
Both Power Supply Units, HLS PS25 and HLS PS50, are very similar: they
consist of a 2x65W, which means 130W in HLS PS50 and 1x65W in HLS
PS25 and a standard module control which supervises the entire power
supply.
HLS PS25 and HLS PS50 power supplies provide 2.5 Amp and 5 Amp
respectively and 300mA to 600mA of them are dedicated to charge
batteries. These power supplies are able to supply either up to 1.10 and
2.20 Amp current at each PSO1 and PSO2 outputs. This is the default set
up (DIP SW1 ON, up position). However, power supplies can also supply all
the current in only one output by placing the DIP SW1 in the down position,
OFF. This way, all the current (2.20Amp or 4.40Amp respectively) will be
supplied through PSO1 output.
SW1 up
SW1 down
SW1 up
SW1 down
HLS PS25 & HLS PS50 User Manual
22