Taurus Ultravapeur Non Stop Pro Mode D'emploi page 20

- Turn on the iron and the heater, by pressing
the corresponding switches. The respective
pilot lights will turn on. (Fig. 2).
- Wait until the pilot light (C) steam ready
indicator is connected.
- The appliance will be ready to use for
ironing. From this moment, the pilot light
steam ready indicator (C) will switch on and
off automatically, according to the steam
consumption. You will also hear a slight sound
intermittently, caused by the water pump that
replaces water in the heater. Continue ironing
normally.
- When the water reaches a minimum level
in deposit J, fill it up without exceeding the
maximum level.
Ironing with steam:
- Ironing can be carried out with steam always
when the deposit contains water and the
selected temperature is suitable.
The appliance has a control (H), which
enables the steam control to be blocked thus
obtaining continuous steam without having to
constantly press the steam blast control.
Steam flow control: (Fig. 2)
- Control (F) on the appliance allows the
steam flow to be regulated.
How to iron in a vertical position (Fig. 5)
It is possible to iron hanging curtains, items of
clothing on its hanger, etc. To do so, follow the
instructions:
- Select the maximum temperature of the iron,
while turning the temperature regulator of the
iron in a clockwise direction (Fig. 1).
- Move the iron in a top to bottom direction
while pressing the steam control (G).
Important: for cotton and linen, it's
recommended to put the iron base in contact
with the material. For other more delicate
fibres, it's recommended to keep the iron
base at some centimetres of distance.
Once you have finished using the
appliance:
- Select the minimum position (MIN) via the
temperature control dial.
- Unplug the appliance from the mains.
- Remove the water from the deposit.
Temperature safety protector:
- The device has a temperature safety
protector, which protects the device from
overheating.
Cleaning
- Disconnect the appliance from the mains
and allow it to cool before undertaking any
cleaning task.
- Clean the equipment with a damp cloth with
a few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an
acid or base pH such as bleach, or abrasive
products, for cleaning the appliance.
- Do not submerge the appliance in water or
any other liquid, or place it under a running
tap.
How to deal with lime scale incrustations:
- For the appliance to work correctly it should
be kept free of lime scale or magnesium
incrustations caused by the use of hard water.
- To prevent this kind of problem, we
recommend the use of distilled water.