Installation Instructions; Required Tools - Lithonia Lighting CNY LED Directives D'installation

FIXTURE PACKING LIST
Description
1) Fixture Housing ..............................................................................1
2) Mounting plate ................................................................................1
3) Locking screw .................................................................................1
4) Support loop ...................................................................................1
5) 1/2" 8-32 & 10-24 J-Box Mounting screws* .................................4
6) Wire Nuts* ......................................................................................3
7) Wire Plug* ......................................................................................1
*Contained in parts packs
Mounting Hardware and
Silicone Sealant Required - Purchase Separately

REQUIRED TOOLS:

Remove fi xture components and parts pack. Check to ensure all
parts are included. Note: Account for small parts and destroy packing
material, as these may be hazardous to children.
Turn OFF Power at fues or circuit breaker box!
CAUTION: Do not rely on wall switch alone to turn off power.
Not suitable for use with dimmers, motion sensors or other remote devices.
For j-box mounting see Figure A
1. Remove mounting plate (2) from top of the fi xture housing (1) by
loosening locking screw (3) on side and sliding plate to disengage the
mounting plate from the holding brackets on top of the housing.
3) Locking Screw
2. Install mounting plate to junction box using mounting screws
(5) or to ceiling or wall if using conduit.
positioned to allow the fi xture to be "square" with the sides of the
fi xture.
Hang the fi xture from the support loop (4) while wiring the unit.
Quantity
2) Mounting Plate
1) Fixture Housing
Note: Brackets should be
4) Support Loop
Figure A

INSTALLATION INSTRUCTIONS

3. Install the fi xture housing to the mounting plate by sliding fi xture
onto holding brackets on fi xture housing and tighten locking screw to
secure fi xture.
For Pendant Mounting see Figure B
1. Remove Lens & Refl ector. Disconnect orange wire connector. Note:
Do not touch LED!
2. Remove Mounting plate and rubber wire plug from the top of fi xture
to expose the NPS threads.
3. Feed input leads through a 3/4" threaded conduit pipe and screw con-
duit pipe into fi xture threading. Note: Seal thread using Tefl on tape or
silicone sealant.
4. Make wire connections, re-connect orange wire connector and rein-
stall Refl ector and Lens.
For Conduit Mounting see Figure C
1. Remove rubber wire plug and replace with wire plug (7) from parts
pack before mounting fi xture to ceiling or wall (Follow step 1 & 2 for
j-box mounting)
2. Remove Lens & Refl ector. Disconnect orange wire connector. Note:
Do not touch LED!
3. Remove conduit plug. Feed input leads through 1/2" conduit pipe and
screw pipe into fi xture threading. Note: Seal thread using Tefl on tape or
silicone sealant.
4. Make wire connections, connect orange disconnect and reinstall
Refl ector and Lens.
Figure B
CAUTION: WIRING AND FIXTURE OPERATION
Make sure power is turned off .
Connect fi xture to supply wires rated for at least 75°C (167°F)
To Ground fi xture use Wire Nut to connect the (copper) house supply
ground wire & the (green) fi xture ground wire. Note: If house wiring
does not include a ground wire, consult your local electrical code for
approved grounding methods.
For proper connection, place wire nut over
wires and twist clockwise until tight.
To connect supply wires use Wire Nuts to connect the black fi xture wire
to the black power supply wire and the white fi xture wire to the white
(neutral) supply wire.
Turn on electricity at fuse or circuit breaker and verify success of installation.
page 3
Figure C