Berner BMM 1000 Notice Originale page 9

16. Do ensure that the handle bars are dry, clean and free from oil and
grease.
When the tool is operated manually, make sure that you always hold the
tool with both hands and you stand in a firm position. Be aware of the
reaction moment of the tool.
Operating the machine
Wrong use may result in damages. Therefore, the following instructions
shall always be observed:
Use stirrers recommended by the manufacturer (maximum diameter: 120
mm with M14 thread).
Do not overload the machine in a way that causes a standstill.
Tool change
Caution!
Do always remove the power plug before carrying out any work on the tool.
You may catch your fingers when inserting the tool. Therefore, do always
wear protective gloves when changing tools.
The work spindle of the tool is provided with a M14 internal thread.
Keep thread and front surfaces clean.
Do use a SW 22 spanner to remove the stirrer and to hold up the work
spindle.
Switching the machine on and off
Short-Time Operation
Starting the machine:
Stopping the machine: Release on/off switch
Permanent Operation
Starting the machine:
engage the lock button
Stopping the machine: Press on/off switch again and release it
Press on/off switch
Press on/off switch and while keeping it pressed,
8