Lindy BTA-30 Manuel De L'utilisateur page 3

User Manual
Installation
Bluetooth Status
(Blue)
NFC tag area
Operating via USB power (Recommended)
Connect the supplied USB Type A to Micro-B cable
to the Power & Charging port of the BTA-30 and
connect this to a free USB port on your HiFi, TV or
LINDY USB power adapter.
Connect the BTA-30 to your HiFi, Headphones or speaker system with the included 3.5mm cable.
Operation
Power on the BTA-30
1. Press & hold the Power Button to turn on the BTA-30. The Bluetooth Status light with flash Blue and you
can begin the Bluetooth Pairing process.
2. Press & hold the Power Button again to turn the Receiver off.
Pairing with NFC devices
1. Start the NFC function on your device.
2. Tap your source device on the top of the LINDY BTA-30.
3. Your device may prompt you to proceed with pairing, if so select yes.
4. A connected to "LINDY BTA-30" message will appear on your source device. You can now play audio via
the BTA-30.
Pairing with Bluetooth devices (without NFC)
1. Activate your source device's Bluetooth and search for available devices
2. Press and hold the Power Button until you hear four tones and after a few seconds, two tones.
3. Select the "LINDY BTA-30" and follow the onscreen prompts. If a PIN is required enter "0000" or "1234"
4. Your source device will connect to the BTA-30 and you can start playing audio from your device.
3.5mm Audio Out
Low Power / External
Power / Charge Indicator
(Red)
USB Micro-B
Power & Charging
Speakerphone Mic
Operating via the internal battery
Ensure the BTA-30's internal battery is fully charged.
2
approximately 12 hours of operation
hours charging provides
English
Power Button
Speakerphone
Pairing Button
a full battery &