THANK YOU
for purchasing the Definitive Technology ProCinema 6D System. This high-performance six-speaker
system is designed to deliver equally superb sound for home theater and music. Please read the
instructions carefully to familiarize yourself with the speaker system.
PROCINEMA 6D SYSTEM
Overall Frequency Response: 22 Hz – 30 kHz
PROCENTER 6D CENTER CHANNEL
Dimensions:
10.5" W x 4.25" D x 4" H
Frequency Response:
55 Hz – 30 kHz
Efficiency:
89 dB
Nominal Impedance:
Compatible with 4 – 8 ohm outputs
Driver Complement:
Two 3.25" BDSS bass/midrange drivers
coupled to two 3.25" pressure-driven
planar low-frequency radiators, 1"
Pure Aluminum Dome Tweeter
Recommended
Amplification:
10 – 175 watts
PROSUB 6D SUBWOOFER
Dimensions:
10.38" W x 13" D x 13" H
Frequency Response:
22 Hz – 150 Hz
Driver Complement:
One 8" woofer with polymer cone,
one 8" infrasonic radiator
Built-in Amplifier:
250 watts RMS
High Pass Filter:
6dB/octave speaker level at 100 Hz
Low Pass Filer:
24dB/octave continuously variable
(40 Hz – 150 Hz)
Power Consumption:
60Hz 100-120V, 2.1A
Recommended Amplification: 10 – 175 watts/channel
PROMONITOR 6D SATELLITE SPEAKERS
Dimensions:
4" W x 4.25" D x 7" H
Frequency Response:
65 Hz – 30 kHz
Efficiency:
88 dB
Nominal Impedance:
Compatible with 4 – 8 ohm outputs
Driver Complement:
One 3.25" BDSS bass/midrange driver
coupled to one 3.25" pressure-driven
planar low frequency radiator, 1" Pure
Aluminum Dome Tweeter
Recommended
Amplification:
10 – 150 watts
REGISTER YOUR NEW DEFINITIVE TECHNOLOGY PRODUCTS AT
definitivetechnology.com/register
PLEASE INSPECT FOR SHIPPING DAMAGE
Each loudspeaker leaves our plant in perfect condition. Any visible or concealed damage
most likely occurred in handling after it left our plant and should be reported at once to
your Definitive dealer or the shipping company which delivered your loudspeaker.
PROCINEMA 6D SYSTEM OWNER'S MANUAL
SAFETY PRECAUTIONS
(Read these safety instructions before operating the unit.)
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE
COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
The lightning flash with arrowhead symbol, within an equilateral
triangle, is intended to alert the user to the presence of uninsulated
"dangerous voltage" within the product's enclosure that may be of
sufficient magnitude to constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended
to alert the user to the presence of important operating and
maintenance (servicing) instructions in the literature accompanying
the appliance.
WARNING:
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT
EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
IMPORTANT SAFETY INSTRUCTIONS
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with dry cloth.
7. Do not block any ventilation openings.
Install in accordance with the manufacturer's instructions.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or
other apparatus (including amplifiers) that produce heat.
9. Do not defeat the safety purpose of the polarized or grounding-type plug. A
polarized plug has two blades with one wider than the other. A grounding type
plug has two blades and a third grounding prong. The wide blade or the third
prong are provided for your safety. If the provided plug does not fit into your
outlet, consult an electrician for replacement of the obsolete outlet.
10. Protect the power cord from being walked on or pinched particularly at plugs,
convenience receptacles, and the point where they exit from the apparatus.
11. Only use attachments/accessories specified by the manufacturer.
12. Use only with the cart, stand, tripod, bracket, or table specified
by the manufacturer, or sold with the apparatus. When a cart is
used, use caution when moving the cart/apparatus combination
to avoid injury from tip-over.
13. Unplug this apparatus during lightning storms or when unused
for long periods of time.
14. Refer all servicing to qualified service personnel. Servicing is required when
the apparatus has been damaged in any way, such as power-supply cord or plug
is damaged, liquid has been spilled or objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture, does not operate normally, or has
been dropped.
15. Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
FCC INFORMATION
(FOR U.S. CUSTOMERS)
1. COMPLIANCE INFORMATION
This product complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this product may not cause harmful interference, and (2)
this product must accept any interference received, including interference that may
cause undesired operation.
Sound United, LLC
1 Viper Way, Vista, CA 92081
United States
Phone: +1 760-536-5300
2. IMPORTANT NOTICE: DO NOT MODIFY THIS PRODUCT
This product, when installed as indicated in the instructions contained in this manual,
meets FCC requirements. Modification not expressly approved by Sound United may
void your authority, granted by the FCC, to use the product.
3. NOTE
This product has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This product generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this product does cause harmful interference to
radio or television reception, which can be determined by turning the product OFF
and ON, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the product into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the local retailer authorized to distribute this type of product or an
experienced radio / TV technician for help.
4. IMPORTANT (FOR NETWORK MODEL)
When connecting this product to network hub or router, use only a shielded STP
or ScTP LAN cable which is available at retailer. Follow all installation instructions.
Failure to follow instructions could void your authority, granted by the FCC, to use
the product.
5. CAUTION (FOR BLUETOOTH/WI-FI MODEL)
• To comply with FCC RF exposure compliance requirement, separation distance of at
least 20 cm must be maintained between this product and all persons.
• This product and its antenna must not be co-located or operating in conjunction
with any other antenna or transmitter.
IC INFORMATION
(FOR CANADIAN CUSTOMERS)
CAN ICES-3 (B) / NMB-3 (B)
CAUTION:
To completely disconnect this product from the mains, disconnect the plug from the
wall socket outlet. The mains plug is used to completely interrupt the power supply to
the unit and must be within easy access by the user.
CAUTIONS ON INSTALLATION:
For proper heat dispersal, do not install this unit in a confined space, such as a
bookcase or similar enclosure.
Amplifier: 0.3 m or more
Other units: 0.1 m or more
CAUTION (FOR AMPLIFIER):
HOT SURFACE. DO NOT TOUCH.
The top surface over the internal heat sink may become hot when
operating this product continuously. Do not touch hot areas,
especially around the "Hot surface mark" and the top panel.
HOT SURFACE MARK
NOTES ON USE
WARNINGS
• Avoid high temperatures. Allow for sufficient heat dispersion when installed in a rack.
• Handle the power cord carefully. Hold the plug when unplugging the cord.
• Keep the unit free from moisture, water, and dust.
• Unplug the power cord when not using the unit for long periods of time.
• Do not obstruct the ventilation holes.
• Do not let foreign objects into the unit.
• Do not let insecticides, benzene, and thinner come in contact with the unit.
• Never disassemble or modify the unit in any way.
• Ventilation should not be impeded by covering the ventilation openings with items,
such as newspapers, tablecloths or curtains.
• Naked flame sources such as lighted candles should not be placed on the unit.
• Observe and follow local regulations regarding battery disposal.
• Do not expose the unit to dripping or splashing fluids.
• Do not place objects filled with liquids, such as vases, on the unit.
• Do not handle the mains cord with wet hands.
• When the switch is in the OFF (STANDBY) position, the equipment is not completely
switched off from MAINS.
• The equipment shall be installed near the power supply so that the power supply is
easily accessible.
• Do not keep the battery in a place exposed to direct sunlight or in places with
extremely high temperatures, such as near a heater.
• Do not bend forcedly the plug on the equipment for the connection between the
connector and micro USB/USB cable.