Chapter 5: Commercial Interface Menus
Power Management
Commercial Interface
Commercial Interface
On
Clone Management
Channel
OSD
Source
Volume
Pillow Speaker
Power Management
Key Management
Reset Commercial Interface
OK
ENTER
- Auto Power On : This function sets the power state when AC power is applied to the TV.
+ Off : TV will go to stanby mode
+ On : TV will turn on
+ Last : TV will resume the state it was in before AC power was removed.
- Auto Power Off : This function assigns the amount of time an inactive TV will remain on. It can be used by
your facility to save energy.
- Power Always On : TV can not be turned off.
- No Signal Power Off: If there is no signal on the TV for 5 minutes or more, this function turns off the TV
automatically.
Key Management
Commercial Interface
Commercial Interface
On
Clone Management
Channel
OSD
Source
Volume
Pillow Speaker
Power Management
Key Management
Reset Commercial Interface
OK
ENTER
- Key Lock : This setting disables the keys on the front of the TV.
- RCU Type : This function assigns RCU type as TV1, TV2, TV3. This is used when more than 1 TV is being
installed in the same room.
Note : The remote must be configured to send the matching RCU Type corresponding to this setting.
This is done as follows : On the R130 K1 remote, press hold <SYSTEM> and <1> keys for 5 seconds to set it
to "TV1". Press and hold <SYSTEM> and <2> keys for 5 seconds to set it to "TV2". Press and hold <SYS-
TEM> and <3> keys for 5 seconds to set it to "TV3".
- Guest Menu Lock: Enables / Disables the guest menu.
Reset Commercial Interface
Commercial Interface
Commercial Interface
On
Clone Management
Channel
OSD
Source
Volume
Pillow Speaker
Power Management
Key Management
Reset Commercial Interface
OK
ENTER
- This function will reset all data in the commercial interface menu to the factory defaults.
Chapter 5
Commercial Interface
F F G G
Auto Power On
G G
Auto Power Off
G G
Power Always On
G G
No Signal Power Off
G G
G G
G G
G G
G G
G G
Select
Back
MENU
Commercial Interface
F F G G
Key Lock
G G
IR(RCU) Type
G G
Guest Menu Lock
G G
G G
G G
G G
G G
G G
G G
Select
Back
MENU
F F G G
G G
Reset Commecial Interface
G G
G G
OK
G G
G G
G G
G G
G G
G G
Select
Back
MENU
Off
F F G G
Off
F F G G
Off
F F G G
On
F F G G
Select
Back
MENU
On
F F G G
TV1
F F G G
Off
F F G G
Select
Back
MENU
Cancel
39