PC Locs LocknCharge iQ 10 Sync Charge Station Instructions D'utilisation page 2

iQ 10 Sync Charge Station
Follow these instructions for easy and fast set-up of your iQ 10 Station.
PC Locs, LocknCharge and the Padlock device are Trademarks of IWS Global Pty Ltd.
Disclaimer.
This information is the intellectual property of IWS Global Pty Ltd and may not be distributed, duplicated
or copied in part or full without the written permission. Since the use of this information, the equipment
connected and the conditions by which any IWS Global product is used is beyond the control of IWS Global,
it is the obligation of the owner and/or user to determine the correct and safe use of any equipment and
product. To the extent that the law permits, any liability which may be incurred as a result of the use or
future use of a product manufactured or sold by IWS Global is limited to the cost of repairing or replacing the
failed product or component at the discretion of IWS Global either within, or outside of warranty periods,
and does not extend to any loss or damage which may be caused as a consequence of misuse or failure of
the equipment or product or the information contained herein. IWS Global shall not in any event be liable for
economic loss of profits, indirect, special, bodily injuries or consequential damages.
Specifications and images are for illustration purposes only. Final product may differ and is subject to change
without notice.
STEP 1 - Unpacking the iQ 10 Station and removing the compartment lid
After unpacking, open the door.
Undo the two thumb screws to release the power
compartment lid.
Congratulations on your purchase.
Copyright IWS Global Pty Ltd, May 2014.
iQ 10 Charging Station
Remove the baskets and accessories.
Push the compartment lid up through the centre
hole from inside the iQ 10 Station.