Installing Exterior Assembly - Honeywell 8732001 Guide De Configuration Et D'utilisation

INSTALLING EXTERIOR ASSEMBLY
6. INSTALLING THE EXTERIOR ASSEMBLY
Note: Work with the Door Open for easy access. To access the mounting plate, unpack
the Interior Assembly and remove the battery cover by sliding the cover upward. Locate
the screws holding the Mounting Plate to the Interior Assembly. Remove the screws to
release the Mounting Plate from the Interior Assembly.
a. Unpack the Exterior Assembly. Use care to not scratch the green circuit board
during handling and installation.
b. Check that the Rubber Gasket is properly seated on the Exterior Assembly
(Figure 6a-b).
c. Insert the Exterior Assembly onto the door with the tailpiece going through the
Latch spindle in the VERTICAL POSITION. Route the Control Wire through
the door over the Latch (Figure 6c).
Rubber
Gasket
7. SECURING THE EXTERIOR ASSEMBLY TO THE DOOR
a. From the side marked "This side against door",
route the Control Wire through the rectangular
slot in the Mounting Plate (Figure 7a).
b. Place Mounting Plate against door with tailpiece passing
through the center hole in the three hole set (Figure 7b).
c. Secure the Mounting Plate to the Exterior Assembly using
two 7/8" (22mm) Screws (Figure 7c).
d. Hand tighten with a Phillips Screwdriver leaving loosely
connected (Figure 7d).
e. Check that the Rubber Gasket is properly aligned and correct as necessary (Figure 7e).
f. Check vertical alignment of the lock (Figure 7f).
g. Tighten securely with a hand held Phillips Screwdriver. DO NOT OVER TIGHTEN
8. OPTIONAL INSTALLATION
a. Using a 1/16" (2mm) drill bit, drill a pilot hole in your door
using the Mounting Plate upper hole as a guide (Figure 8a).
b. Insert one 3/4" (19mm) screw and tighten.
NOTE: Rotate knob to ensure the latch is opening and closing easily.
Tailpiece
(Vertical)
Figure 6a-b Figure 6c
Control Latch
Wire Hole
NOTE: Tailpiece must be
positioned vertically
Mounting Plate
3/4" (19mm) screw
(Optional Installation)
Control Wire
7/8" (22mm) screws
Figure 7a-7f
Figure 8a
Page 4