Symbols Used; Intended Use - Palazzetti CONNECTION BOX Notice D'installation

1 GENERAL
PREAMBLE
PALAZZETTI equipment is manufactured and
tested in conformity with the safety standards
indicated in the applicable European directives.
Any printing, translation and reproduction -
even in part - of this manual must be authorised
by PALAZZETTI. The technical information,
Do not operate the product unless you have
fully understood the contents of this manual; in
case of doubt, always contact PALAZZETTI for
further information or service.
PALAZZETTI reserves the right to modify
characteristics of the product at any time,
without prior notice.

1.1 SYMBOLS USED

The following symbols are used throughout this
manual to highlight important points:
INSTRUCTION: Information about the correct
use of the appliance and the responsibilities of
operators.
CAUTION: Indicates an aspect deserving special
attention.
DANGER: Indicates an important behaviour rule
for preventing injuries or damage to objects.

1.2 INTENDED USE

The connection box is a device for interfacing a
Palazzetti pellet stove to a cellular phone or the
internet.
You can use the Connection Box on your mobile
device just by installing the appropriate app
"PALAZZETTI", available on the store of your
device.
The connection box may only be used with
compatible stoves.
The appliance is not intended for use by people
(including children) with reduced physical,
experience or knowledge, unless they are
adequately supervised or instructed on the
appliance's use by a person responsible for their
safety.
The above intended use is the only one permitted
by the manufacturer: do not use the product for
instructions.
2 SAFETY
PRECAUTIONS
Observe the instructions contained in this
manual.
The user must comply with all relevant local,
national and international safety regulations.
Do not make any electrical connections using
temporary or uninsulated cables.
Verify that the electrical system's earthing device
Prior to assembling or dismantling the product,
the installer must observe the safety precautions
A) refrain from working in adverse conditions;
B) work in perfectly sound psycho-physical
conditions and check that his personal
protective equipment is intact and in good
working order;
C) wear protective gloves;
D) wear safety shoes;
E) use electrically insulated tools;
F) ascertain that the area in which the assembly
and dismantling are to be done is free of
obstacles.
Disconnect the power supply before working on
electrical or electronic parts and connectors.
11 11