Electrical Connection; Connecting To The Mains Supply; Using The Appliance; Description Of The Functions - Argo VD06S Mode D'emploi

8
Important: On completion of the drying cycle, disconnect the appliance from the mains sup-
ply to prevent young children from operating the drier.
9
10
11
Energetic
Delicate
SM1888
INSTALLING THE APPLIANCE

ELECTRICAL CONNECTION

Make sure that the voltage indicated on the identification plate attached to the
back of the appliance corresponds to that of the mains supply.
On completion of the installation, the appliance must be connected to the mains
supply through a two-pole switch.
All cutouts, electric wiring and mains sockets must have a rating such that
enables them to support the maximum load indicated on the identification plate.
The mains supply to which the appliance is connected must be fitted with an
earthing system. If this is not the case, the manufacturer will not be held liable
for any incidents that may occur (fig. 8).
If the power supply cable is damaged in any way, contact the appropriate spe-
cialised customer technical service centre.
The drier must not be connected to the mains supply using indirect methods
such as extension leads or multiple adapters.
Position the appliance so that the power supply cable is easily accessible for
disconnection when the need arises.

USING THE APPLIANCE

DESCRIPTION OF THE FUNCTIONS

Drying time control knob: Rotate the knob to select the required drying times
(fig._9).
(Refer to the program table to select the program according to the type of fabric)
At the end of each drying cycle, the appliance effects a 10 - 15 minute cooling
cycle, during which time the appliance is still switched on.
Start button: Press this button to start the drying cycle (the indicator will light
up).
Delicate or energetic drying button: This button is used to select the type of
drying cycle to run: Energetic or delicate (fig.11).
15
GB