EnGenius EP801 Guide Rapide D'installation page 2

b. Half duplex broadcasting to base stations
Re：Press the
5. Left/Right Soft Keys (
a. Make menu selection.
6. Up( ) /Down(
a. Scroll through records and menu selections.
b. Adjust receiver voice volume when in the Talk mode.
c. Press to adjust ringer volume when in the Standby mode.
d. Press to enter phonebook when in the Standby mode.
7. END; On/Off Key (
a. Ends a call.
b. Leaves current menu operation, up one level.
c. Press for 3 seconds to off the power
8. CALLER ID Key (
a. Review caller ID list.
b. Including received and missed caller ID.
Base features
1. RESET Button
a. Restores base station to factory settings
b. Reset button is indented to prevent accidental system reset.
c. All handsets (including administrator) and additional base(s) need to be re-registered after a base station reset.
2. Registration Button (REG)
Enters registration mode along with handset, assigns handset
ID (11-19).
3. Dialing Keys
a.
Enter the phone no after pressing the Speakerphone key.
b.
Enter the handset ID or Group ID when making the
intercom call or broadcast.
c.
Enter the phone no when storing the base speed dial
directory.
4. Function Keys
a. TRANSFER (
the call to a registered handset.
b. MEMORY (
memory of base unit. Up to 20 entries. Or retrieve a phone
number from the speed dial memory during the talking.
c. HOLD ( ): press the key to put the call on hold.
d. FLASH ( ): press the key to send a Flash signal to phone line to retrieve a dial tone after the call ends, or to
perform the call waiting feature provided by local phone companies during a call.
e. REDIAL/P (
storing the speed dial memory.
5. VOLUME keys (
a. Increase or decrease the ringer volume during standby mode.
b. Increase or decrease the voice volume during talk mode.
6. SPEAKERPHONE key (
a. Press the key to get the dial tone, followed by phone number to make outgoing call.
b. Press the key again to hang up the call.
c. When enable the speakerphone, the backlight of the key will be turned on too.
7. INTERCOM/BROADCAST Key (
a. Enter handset ID then press the key to enable the 2-way intercom feature.
b. Enter handset ID then press and hold the key for over one second to enable the broadcast feature.
Re: Press the
key on the side of handset to activate the broadcast function.
)
) Scrolling Keys
)
)
): during talk, press the key to transfer
): store phone number into speed dial
): press the key to retrieve the last dialed number. Or store a pause time (1 second) while
and )
)
)
Key without entering handset ID first, all registered handset will be enabled.
2