Change Filter - Schwaiger 658002 Mode D'emploi Et Consignes De Sécurité

Sleep-Mode
Press the Sleep-mode button
level. In Sleep-mode, only the Sleep-mode button
and the Fan speed indicator
If you change the speed during Sleep-mode either to the medium speed using the Fan speed button
speed using the Turbo button
Timer
The device has a timer function that allows you to select the operating time from four different times. To do so, press the
Timer button to set the timer to 1 hour. A short tone sounds to confirm this and the indicator „1 h" lights up blue on
12
the control panel . Press the Timer button
7
sets the timer to 4 hours, and pressing the button a fourth time sets the timer to 8 hours. If you press the Timer button
for the fifth time, the timer is switched off again. The set duration lights up blue on the control panel
1 h (one hour) – 2 h (two hours) – 4 h (four hours) – 8 h (eight hours)
During operation with timer, the respective indicator of the operating time also changes. After the time has already elap-
sed (1 hour, 2 hours, 3 hours, 4 hours, 6 hours, 7 hours), the display changes to the respective remaining time. When
the timer has expired, the device switches off automatically.
While the timer is activated, all other functions of the device can still be used and set. The timer remains unaffected.
If the maximum speed is set with the Turbo button
the timer or the runtime of the maximum speed. This will still be ended automatically after 1 hour at the latest and the
speed changes to the medium level.

CHANGE FILTER:

CAUTION
Before changing the filter
any voltage source.
After a total of approx. 3,000 hours of operation, the filter
This is indicated by the red Filter reset indicator
1. Take the device in your hand and turn the lid on the air inlet
2. When the lid is turned into „open" position, pull the lid up to open the housing.
3. Hold both ends of the filter
be used to remove the filter.
4. Insert the new filter into the unit according to the orientation with the cloth flaps facing upwards. The other way
around, the filter cannot be inserted into the housing because the upper edge of the filter is wider than the lower
edge and blocks accordingly.
5. Then place the concave lid back onto the lower housing
6. Finally, turn the lid into „close" direction until you hear a click.
To subsequently reset the Filter reset indicator
short confirmation tone and the red light of the indicator will go out.
If you change the filter in advance, before the Filter reset indicator
prox. 3 seconds until you hear a short tone, and the Filter reset indicator
the filter change indicator. You will then hear another short confirmation tone and the indicator will no longer light up.
You can purchase a suitable filter from Schwaiger under article number 658033.
to enter Sleep-mode. The device then operates extremely quietly at the lowest speed
15
15
do not light up.
19
, Sleep-mode is automatically ended.
16
a second time to set the timer to 2 hours. Pressing the button a third time
12
, make sure that the mains plug
2
14
and pull it out together with the filter bowl. The filter has two small cloth tabs that can
2
to 0, press and hold the button for approx. 3 seconds. You will hear a
14
is illuminated. The On/Off button
during operation with timer, this does not change the duration of
16
is disconnected and the unit is no longer connected to
11
has reached the end of its service life and must be replaced.
2
on the control panel . To change the filter
7
on the lower housing
5
.
4
starts to light up, press and hold the key for ap-
14
14
13
USER GUIDE
, the illuminated lamp ring
17
, proceed as follows:
2
into „open" direction.
4
lights up red. Repeat this procedure to reset
8
or to the highest
18
:
7