Drain Pump (Optional); Request And Installation Of Optional Accessories After Purchase; Using The Machine; Check Filter And Overflow Pipe - AFG ACO1000 Manuel D'installation, Utilisation Et Entretien

ENGLISH
DRAIN PUMP (Optional) (Fig. 2):
If the washing water drainage trap is located
high up, we recommend fitting a drain pump. At
the time of ordering, depending on the model, the
machine can be supplied complete with a drain
pump.
A: Correct installation;
B: Incorrect installation.
1. Water level in tank;
2. Waste pump;
3. Drain under the tank level water;
4. Pump delivery side;
5. Water column for priming the pump;
6. Drain over the tank water level.
N.B. To empty the tank: Take out the overflow
pipe and leave the door open. Then press the
"drain pump" button for at least 2 seconds; the
drain pump will start to empty the tank. At the
end of the drain cycle , switch off the machine.
During the wash-rinse cycle the excess water
is automatically drained out.
REQUEST AND INSTALLATION OF OPTIONAL
ACCESSORIES AFTER PURCHASE:
Should it become necessary to fit one
or more optional accessories, make
sure
"professional
"personnel belonging to the nearest
after-sales centre".
G
CHECK FILTER AND OVERFLOW PIPE: With the
machine disconnected from the power mains,
open the door and remove the basket:
Put the overflow pipe in its seating inside
the tank.
Ensure that the filter is properly set into its
housing making sure this is properly secured
to the bottom of the machine.
N.B. - We recommend that the machine is
not used without the filter in place.
WATER SUPPLY CONNECTIONS AND
PREPARING FOR WASHING (water loading):
Open the water supply tap;
fit the plug in the power socket;
switch on the machine;
make sure the door is closed;
from the machine control panel, press the
machine switch-on button to run water into
the tank.
After about 30/35 minutes the warning-light
Fig. 2 automatically lights up and the machine is ready
for the first washing cycle.

DETERGENT:

The detergent needs to be an absolutely NON-
FOAMING type and suitable for use in industrial
glass and dishwashing machines.
We recommend the use of liquid detergents.
Correct dosage is most important for achieving
good washing results and for proper operation
and long life of the machine. In dosing the
detergent, always follow the manufacturer's
instructions. Doses can vary according to the
hardness of the water and the amount of dirt-
grease still on the dishes (the greater the
hardness and the dirt, the greater the amount of
detergent).
22
installation is
personnel"

USING THE MACHINE

done by
or