Step 6 - Option 2: Install On A Solid Concrete Or Concrete Block Wall - Dynex DX-DTVMFP23 Guide D'installation

STEP 6 - Option 2: Install on a solid concrete or concrete block
wall
You'll need
Wall plate (A)
P (4)
CAUTION: To prevent property damage or personal injury, never drill into mortar
between blocks. Mount the wall plate directly onto the concrete surface.
Align the wall plate (A) at the height you determined in the previous step, make
1
sure that it is level, then use a pencil to mark the lag bolt hole locations (4). Remove
the wall plate (A).
Drill pilot holes to a depth of 2.36 in. (60 mm) using a 3/8 in. (10 mm) diameter
2
masonry drill bit.
The minimum distance between the top two fasteners cannot be less than 16 in. (40 cm)
Concrete
wall
Q (4)
O (4)
* Minimum solid concrete thickness: 8 in. (203mm).
* Minimum concrete block size: 8 x 8 x 16 in. (203 x 203 x 406 mm).
www.dynexproducts.com
Pencil
1/2" socket wrench
Level
2.36 in. (60 mm)
DX-DTVMFP23
Drill
3/8 in. masonry drill bit
3/8 in.
(10 mm)
17