Starting The Machine - Kunzle & Tasin Bona Dual Edge Manuel D'utilisation

Starting the Machine

To start the machine proceed as follows:
1.
Become familiar with
the machine and read all
instructions & safety notices.
Ensure that all operators read
this manual.
16
2.
Bring the machine to the
place of work. If the machine
has been removed from the
original packaging, pull the
suction pipe locking piston
(A) and turn the pipe 180°.
3.
If using DCS, connect DCS
cu to shorter DCS pipe and
fasten with a clamp.
If using a dust bag, place the
dust bag on the suction pipe
by tying the cord over the
flange.
Bona Dual Edge Manual
4.
Fit the disc in accordance
with the 'Abrasive Assembly
Procedures' (pg. 18).
Only use discs with a
diameter of 100mm.