Haier LEF65V200S Mode D'emploi page 29

1
Insert the batteries into the remote
Lift the cover on the back of the remote upward
gently. Install two AAA batteries. Make sure to
match the + and - ends of the batteries in the
battery compartment (observe the correct
polarity) Replace the cover.
Connect the Aerial/Cable
2
straight to your TV
AERIAL
3
Connect the TV to the mains socket
insert plug...
Quick Start Guide
4
To switch the TV on
Connect the power cord to the 220-240V AC, 50 Hz.
To switch on the TV from standby mode either:
1. Press the " " button, P+ / P- or a numeric button
on the remote control.
2. Press the side function switch until the TV comes
on from standby.
5
HDMI input
PLEASE ENSURE BOTH UNITS ARE SWITCHED
OFF BEFORE CONNECTING. Use a HDMI to HDMI
cable to connect the two units together. To select the
HDMI input, press the SOURCE button on the remote
control. Each time it is pressed, the on-screen menu
confirms your selection.
CABLE
6
Start Auto Setup procedure
IMPORTANT: Ensure that the aerial/cable
connected and a Common Interface module is not
inserted before switching on the TV for the first
time installation. Do not insert a common interface
module during the search process.
When turned on for the first time, the language
selection screen is displayed. Select the desired
language and press OK.
First Time Installation (FTI) screen will be displayed
next. Set your preferences using the navigation
buttons and when finished, press OK to continue.
You can activate Store mode option to be available in
"Other settings" menu and your TV's features will be
illustrated on the top of the screen. A confirmation
screen will be displayed. Select YES to proceed.
If Home Mode is selected, Store mode will not be
available after the First Time Installation. Press OK
button to continue.
To HDMI connection on
the device
Aerial Installation
If you select AERIAL option from the Search Type
screen, the television will search for digital terrestrial
TV broadcasts.
NOTE: You can press MENU button to cancel.
After all the available stations are stored, the Channel
List will be displayed on the screen. If you like how the
channels are sorted according to the LCN (*), please
select "Yes" and than press OK.
Press MENU button to quit channel list and watch
TV.
(*) LCN is the Logical Channel Number system that
organizes available broadcasts in accordance with a
recognizable channel sequence (if available).
Cable Installation
If you select CABLE option and press OK button on
the remote control. To continue, please select YES
and press OK. To cancel operation, select NO and
press OK. You can select frequency ranges from this
screen. Enter the frequency range manually by using
the numeric button.
Note: Searching duration will change depending on
the selected search step.