Table des Matières
Publicité
The appliance must be installed by qualified personnel in compliance with current regulations and regulations in place
UK
relative to domestic electrical wiring and plumbing.
The luminaries must be installed in dedicated rooms and must NOT be installed outdoors.
The appliance must be connected correctly to the mains power supply, i.e. to the terminals marked L
(line), N (Neutral) , otherwise correct operation cannot be assured.
ECOLOGICAL NOTES
Upon completion of the installation phase, please remember to dispose of the packaging and assembly
scraps in accordance with standards in e ect in the country where the product will be used.
PRECAUTIONS
In order to ensure correct installation and maintenance of the
product, the manufacturer recommends careful attention to
the instructions contained in this manual. Compliance with
safety norms and the suggestions described in this
manual will ensure that the product functions perfectly and
that the manufacturer's warranty will be fully applicable.
PRE INSTALLATION CHECKS
Before you start installation it is advisable to:
- check the integrity of the packaging as indicated on the pack;
- check that the product has not received blows or been
tampered with.
Once the product is installed, the manufacturer cannot be
held liable for any of the damage mentioned above.
INSTALLER
A person who is capable of demonstrating to pertinent authori-
ties that he has the knowledge and skill in the application of
national regulatory requirements concerning
electricity, water supply, and disposal.
ATTENTION!
Prior to installation, check that the electrical system is compliant
with standards and laws in e ect and that it is equipped with a
magneto-thermal differential switch with an adequate breaking
capacity and a di erential of 30mA. Connection must be made
in a fixed and permanent manner, with no intermediate connec-
tions, by installing an adequate omnipolar disconnecting switch
with minimum aperture distance of contacts which allows
complete disconnection in conditions of category III, outside of
zones 0-1-2-3 and protected from water splashes (60 cm
laterally beyond the side of the tub or at height of 225 cm from
the floor). (fig. 1)
The power cable must be protected inside the wall by a
corrugated tube or by another system that is compliant with
current standards and certified by the CE directive up to the
connector.
10
INSTALLATION
The installer is responsible for the choice of materials and
complying with standards and laws:
- He must not tamper with the electrical parts of the
product, he must limit himself to connecting and installing
the components as explained in this manual.
- He must guarantee that the work done will not compro-
mise the IP protection level of the luminaries components.
- If the external flexible cable or cord of this luminaire is
damaged, it shall be exclusively replaced by the manufac-
turer or his service agent or a similar qualified person in
order to avoid a hazard.
- To connect the unit to the fixed lighting is necessary to
use a terminal conforming to EN 60998-2-1.
The terminal must be screw Bipolar (L, N), 1.5 mm ², 230 V ~, IP44;
- In the case of a failure or malfunction he must contact
After-Sales Service who will supply original spare parts.
The manufacturer is not liable if the product is installed on
premises where the structures and systems are not to
standard or for work performed
unskilled personnel.
The electrical specification of the product with the CE
mark and relative rating plate values are given on the
label on back of the product. Under on circum
safety, i.e.
stances must this label be removed.
Safety distances and clearances.
by unqualified or
Zone 1
Zone 0
Zone 2
Zone 3
fig.1
24/09/15
Publicité
Table des Matières
