Upright XRT Electric Guide De L'opérateur page 12

M
AINTENANCE
!
Never perform service in the elevating assembly area while the platform is
elevated without first blocking the elevating assembly.
DO NOT stand in elevating assembly area while deploying or storing brace.
DO NOT block elevating assembly with a load on the platform.
S
12
W A R N I N G
E
UPPORTING THE LEVATING
I
NSTALLATION
1. Park the work platform on a firm, level surface.
2. Pull the Chassis Emergency Stop Switch to the ON
position.
3. Pull the Platform Emergency Stop Switch to the ON
position.
4. Turn the Platform Controls Key Switch to ON.
5. Turn the Platform/Chassis switch to CHASSIS.
6. Push the RAISE button to elevate the platform until the
Scissor Brace can be rotated to the vertical position.
7. XRT27E – From the rear of the machine, lift the Scis-
sor Brace from its stowed position. Rotate upward and
outward, then down until it is hanging vertically below
its attachment point.
8. XRT33E – From the left side of the machine, pull the
locking pin securing the brace. Rotate the Scissor
Brace counterclockwise until it is in the vertical posi-
tion.
9. Lower the platform by pushing the Chassis Controls
LOWER button and gradually lower the platform until
the Scissor Brace is supporting the platform.
R
EMOVAL
1. Using the Chassis Controls, gradually raise the plat-
form until the Scissor Brace is clear.
2. XRT27E – Rotate the Scissor Brace outward and
upward over its mounting point until it rests in the
stowed position.
3. XRT33E – Rotate the Scissor Brace clockwise until
the locking pin engages.
4. Lower the platform by pushing the Chassis Controls
LOWER button to completely lower the platform.
!
Figure 10: Supporting the Elevating Assembly
A
SSEMBLY
SCISSOR BRACE
IN REST POSITION
BRACE ROTATES
ROTATE BRACE
CLOCKWISE
TO BLOCK
BRACE RESTS ON
WELDMENT WHEN IN
BLOCKING POSITION
XRT27E
PIN RESTS ON
BRACE WHEN IN
BLOCKING POSITION
TO BLOCKING
POSITION
BRACE RESTS ON
PIN WHEN IN
BLOCKING POSITION
XRT33E
XRT Electric