golmar CD-2PLUS Manuel D'installation page 29

28
D
escription of the configuration dip switch of
module CD-2PLUS.
The SW1 configuration dip switch is found at the upper right
side of the module.
*Factory default
*
In case of crossed line, if it is
removed before 2 minutes (approx.),
the door panel will automatically
reset; in case of more than 2 minutes,
it is necessary to switch it off and then
switch it on.
Set to ON the switch number 1 to programme the column.
This function must be done only in case the module is being used
as column encoder (see page 26).
Once the programming process is finished return the switch to OFF .
Set to ON the switch number 2 to activate the mode "column
encoder".
Set to OFF to activate the mode "porter's exchange interface".
(see pages 25 y 26)
Factory adjustment. Keep it always OFF.
Not used.
The self-testing leds are placed together with
the configuration dip switch.
Green Led
Fixed: Correct operation.
Slow blinking: Programming of panel in progress (SW 2
Quick blinking: Programming has finished.
Red Led
Fixed: There is a door panel configurated as master.
Blinking: There is a crossed line in the installation*
CONFIGURATION
D
escription of the self-testing leds.
in ON).
between bus wires.