Moulinex extenso accessimo Mode D'emploi page 10

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

telescopic crevice tool* (D1) built into the dust
container.
- To clean flat surfaces, fit the brush head* (E2)
onto the end of the telescopic crevice tool*
(D1) built into the dust container.
- To vacuum up water or liquids (only for non-
inflammable and non-corrosive liquids), fit the
scraper head* (E1) onto the end of the telescopic
crevice tool* (D1) built into the dust container.
- Push the switch (B1) to start the appliance.
WARNING: Do not fill above the "Max" level of
4
the Dust/Water container. The Dust/Water
container must be emptied before the appliance
is placed on its storage base.
Note: the storage base* (A) has an accessory
storage compartment (A1) for the scraper
head*(E1) or the brush head* (E2).
C
LEANING THE DUST OR DUST/WATER CONTAINER
- Press the open button of the dust container
3a
(B2) or the dust/water container* (B2), and
remove the container (C).
- Remove the permanent filter (C1) then the filter
3b
holder* (C2) and empty the container (C).
- Gently brush the permanent filter (C1) or wash
it if necessary. Ensure that it is completely dry
and then replace it.
IMPORTANT: every time it is used for a different
purpose (dust or liquid), clean the container and
dry the filter.
- Clean the filter regularly. Only a clean and dry
permanent filter can provide optimal suction
power. Change the filter if it is damaged. Do
not use cleaning products that are too
aggressive or abrasive.
- You can purchase a spare permanent filter
from a Moulinex Approved Service Centre (see
list of Approved Service Centres) or by
contacting the Moulinex Customer Service
department.
Environment
Environment protection
5
first !
Your appliance contains valuable materials
which can be recovered or recycled.
Leave it at a local civic waste collection point.
R
EPLACEMENT OF BATTERIES
This appliance contains Nickel Metal Hydride
batteries that, for safety reasons, may only be
accessed by a Service Centre or qualified
person. To change the batteries (F), contact
your local service centre.
Important!
The rechargeable batteries have been designed
exclusively for interior use. Do not immerse
them in water. Take care when handling the
rechargeable batteries.
*according to model
Do not put batteries in the mouth.
Do not allow the batteries to come into contact
with other metal objects (rings, nails, screws, etc.)
Be careful not to cause a short circuit in the
batteries by inserting metal objects into either
end of the appliance. If a short circuit occurs,
the batteries may become dangerously hot,
and can cause serious burns, or even catch fire.
D
ISPOSING OF THE BATTERIES
Do not dispose of your appliance without first
removing the batteries.
To remove the batteries contact an Approved
Service Centre or proceed as follows:
- Unplug the appliance from the mains.
- Remove the screws on the handle then
remove the casing of the handle.
- Remove the dust or water/dust container*.
- Remove the screws on the appliance body
then separate the 2 elements forming the
*
body.
- Remove the assembly formed by the battery
unit, the motor and the turbine of the
appliance.
- Then disconnect the 2 cables connected to
these 2 batteries.
- Remove the screws on the battery unit, then
remove the batteries from the battery unit.
Do not throw away the batteries with
household waste, take them to your local
Moulinex Approved Service Centre or to a
suitable collection point.
What to do if your appliance
is not working ?
- Check that the appliance is fitted correctly
onto its storage base* (A).
- Check that the cord of the storage base* or
the charger* is plugged in, and the socket is
operating correctly.
- The batteries may be discharged: recharge
the appliance.
- If the appliance loses suction power or
makes an abnormal noise, check that the
accessory is not blocked or that the dust or
dust/water* container is not full.
- In cases of abnormal operation, such as
motor overheating, stop the appliance to
correct the problem (e.g. blockages in the
vacuum inlet or accessory).
- If dust or debris that have been vacuumed
fall back onto the floor or if liquid runs out,
check that the dust or dust/water* container
is not full.
If you have followed all these instructions and
your appliance still does not work :
contact a Moulinex Approved Service Centre
(see list of Approved Service Centres) or
contact our Customer Relations Team:
or consult our website: www.tefal.co.uk
7
0845 602 1454 - UK
(01) 677 4003 - Ireland

Publicité

Table des Matières
loading

Table des Matières