Tools Needed For Assembly; Electrical Requirements - Emerson IDEAL Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

1. Unpacking Instructions
This Manual Is Designed to Make it as Easy as Possible for You to Assemble,
Install, Operate and Maintain Your Ceiling Fan

Tools Needed for Assembly

One Phillips Head Screwdriver
One 1/4" Blade Screwdriver
Materials
Wiring outlet box and box connectors must be of type
required by the local code. The minimum wire would be
a 3-conductor (2-wire with ground) of following size:
Installed Wire Length
Up to 50 ft.
50-100 ft.
Your new ceiling fan will require a grounded electrical
supply line of 120 volts AC, 60 Hz, 15 amp circuit.
WARNING
!
To reduce the risk of fire, electric shock, or personal
injury, mount fan to outlet box marked "Acceptable for
Fan Support of 22.7kg. (50 lbs.) or less", and use
screws supplied with outlet box. Most outlet boxes
commonly used for support of light fixtures are not
acceptable for fan support and may need to be
replaced. Consult a qualified electrician if in doubt.
WARNING
!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box before wiring. All wiring must
be in accordance with National and Local codes and
the ceiling fan must be properly grounded as a
precaution against possible electrical shock.
One Stepladder
One Wire Stripper
Wire Size A.W.G.
14
12

2. Electrical Requirements

(Continued)
Your Emerson Ceiling Fan comes supplied with a
DC Receiver and Fan Wall Control. This system allows
you to regulate your ceiling fan speed and light control.
This Emerson Ceiling Fan may be used with the
following accessory (purchased separately): SR600
Remote Control.
!
Before assembling your ceiling fan, refer to section on
proper method of wiring your fan (page 12). If you feel
you do not have enough wiring knowledge or
experience, have your fan installed by a licensed
electrician.
The outlet box must be securely anchored and capable
of withstanding a load of at least 50 pounds.
If your fan is to replace an existing ceiling light fixture,
turn electricity off at the main fuse box at this time and
remove the existing light fixture.
!
To avoid fire or shock, follow all wiring instructions
carefully.
Any electrical work not described in these
instructions should be done or approved by a licensed
electrician.
Please
call
Emerson
1-800-654-3545 if you have any questions about
installation and operation of this ceiling fan.
4
WARNING
WARNING
technical
support
ETL Model No.: CF330
at

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Cf330bq00Cf330gbq00Cf330grt00Cf330gsw00

Table des Matières