WLAN-Access Points
2330/2330A/2330B
Cable requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 71
Junction box installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 77
Configuring the AP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 80
This document provides basic indoor hardware installation instructions for Models WLAN 2330/2330A/2330B
access points.
For more information about AP installation as well as safety and installation requirements, see the following:
Nortel WLAN-Access Point 2330/2330A/2330B Installation Guide
Note.
correct configuration and operation.
Note.
later) for correct configuration and operation.
Cable requirements
The Ethernet ports on an AP cannot accept a CAT-5 cable that has an uneven sheath such as the one shown in
The RJ-45 connector on the cable will not seat properly in the receptacle on the AP. Use a CAT-5 cable with an even
sheath instead.
WLAN Access Point 2330/2330A require WMS and WSS Release 4.1(or later) for
WLAN Access Point 2330B requires WMS and WSS Software Release 5.0.11(or
Nortel WLAN-Access Point 2330/2330A/2330B Quick Installation Guide
WLAN-Access Points 2330/2330A/2330B 71
Figure
1.